Sony BVP-E30 series Manual - Page 27

Browse online or download pdf Manual for Camcorder Sony BVP-E30 series. Sony BVP-E30 series 34 pages. Sdtv portable cameras
Also for Sony BVP-E30 series: Operation Manual (36 pages), Brochure & Specs (14 pages), Operation Manual (38 pages)

Print Page
Sony BVP-E30 series Manual
Communication method setting
Select enable/disable of network connection.
The setting switches of the respective models are shown below.
. CCU-590/790 : When the switch SW5 of S310 (B-4/side A) of the AT-155 board is set to ON, connection setting on the
network becomes possible. Switching to the communication mode from the connection setting menu
becomes also possible. When connection on network is not required, set it to OFF.
. HDCU1000/1080/1500/3300 : The following two types are shipped depending on the time of manufacture.
(1) The type that the LEGACY/NETWORK selector switch is not installed on the AVP board panel.
When the switch SW5 of S407 (B-4/side A) of the AT-167 board is set to ON, connection setting on the network
becomes possible. Switching to the communication mode from the connection setting menu becomes also possible.
When connection on network is not required, set it to OFF.
(2) The type that the LEGACY/NETWORK selector switch is installed on the AVP board panel.
There are two selector switches. When the network connection is desired, set both of these switches that enable the
network connection.
. SW5 of S407 (B-4/side A) of the AT-167 board
When the switch is set to ON, connection setting on the network becomes possible. When connection on network is
not required, set it to OFF.
. On-panel switch of the AVP board
This is the forced Legacy switch. When the switch is set to the "LEGACY/NETWORK" position, connection
setting on the network becomes possible. When the switch SW5 of S407 (B-4/side A) of the AT-167 board is set to
ON, switching of the communication mode from the connection setting menu is enabled.
When the switch is set to the "LEGACY" position, the communication mode is set to the Legacy mode.
AVP
CCU
POWER
CAM
LOCK
CAM POWER
ON/
OFF
LEGACY
/NETWORK
LEGACY
SYSTEM
/1.001
LINE
DELAY
2WIRE CANCEL
PROD
Panel of the AVP board
ENG
When this switch is used, switching between the network connection and the Legacy mode becomes possible from
the panel. It helps us when the communication mode should be switched in an emergency.
Camera Network System
LEGACY
/NETWORK
LEGACY
3-11 (E)