Cisco TelePresence SX20 Getting Started Manual - Page 10

Browse online or download pdf Getting Started Manual for Conference System Cisco TelePresence SX20. Cisco TelePresence SX20 46 pages. In-room control on touch 10
Also for Cisco TelePresence SX20: Quick Set (8 pages), Getting Started Manual (41 pages), Getting Started Manual (42 pages), Quick Reference Manual (2 pages), Quick Set (2 pages), Quick Reference Manual (2 pages), User Manual (34 pages), User Manual (29 pages), Troubleshooting Manual (37 pages), Regulatory Compliance And Safety Information Manual (9 pages), Setup Manual (8 pages), User Manual (38 pages), Installation Manual (2 pages), User Manual (2 pages), Quick Reference Manual (2 pages), User Manual (37 pages), Manual (45 pages), Manual (45 pages), Installation Sheet (2 pages), Installation Manual (2 pages), User Manual (34 pages), User Manual (5 pages), User Manual (38 pages), User Manual (38 pages), Getting Started Manual (42 pages), Reference Manual (8 pages)

Print Page

Cisco TelePresence SX20 Getting Started Manual

Cisco TelePresence Video Systems

Contents

Configuration tasks (continued)

Setting the H.323 and SIP parameters

(when not set by a provisioning system)

To get online and ready to place and receive calls, your system

must be set up properly. Your system uses either the H.323

protocol or the SIP protocol for video calls.

Choose one of the following methods to set the H.323 and

SIP parameters:

Touch controller

Remote control

and on screen menu

Web interface

D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.

Introduction

User interfaces

Setting date and time

(when not set by a provisioning system)

When setting up your video conference system, you should

check that the date and time settings are correct. Among other

things this information is used to time stamp messages trans-

mitted to gatekeepers and other network elements.

Choose one of the following methods to set the date and time:

Touch controller

Remote control

and on screen menu

Web interface

Configuration

Setting the menu password

We strongly recommend that you set a password for the

Administrator Settings menu.

This menu, which is available on both the Touch controller and

the remote control, gives access to settings that affect the

behavior of the video conference system.

Choose one of the following methods to set-up the menu

password:

Getting Started Guide

Appendices

Remote control

and on screen menu

Web interface

Contacts