Digitek G-Line Pro Installation Instructions Manual - Page 11
Browse online or download pdf Installation Instructions Manual for Security System Digitek G-Line Pro. Digitek G-Line Pro 14 pages.
Print PageThe following 2 procedures below (A or B) can be used for learning additional remote controls and the Digitek G-Link
garage/shed wireless PIR. For further information on the 'Digitek G-Link' visit us at 'www.digitek-moto.com'.
A/ Learn a new device via the alarm Green/Brown wire:
Arm and then dis-arm the alarm system via the original alarm remote control or electronic key.
Lift the seat or open the top-case, if there is no contact switch fitted you will need to ground the alarm
Green/Brown wire.
Connect the alarm White/Violet wire to ground.
Turn ignition key to 'ON'.
Two flashes of the turn indicators and two beeps (high and low) will confirm the system is in learning mode.
Remove the alarm White/Violet wire from ground.
Depending on which device is to be learned either press one of the new remote control buttons OR insert the
electronic key in its receptacle OR make the magnetic contact transmit of the wireless reed switch to be learnt
(bring contact and magnet together and then move apart) OR set the Digitek G-Link garage/shed wireless PIR to
'TX Test' (see relevant kit instructions).
A flash of the turn indicators and a high beep will confirm the operation has been completed successfully.
To learn another device, apply the alarm White/Violet wire to ground for 1 second and repeat one of the above
procedures relative to the device to be learnt.
To exit the learning procedure, turn ignition key 'OFF'.
A low pitched beep and a flash of the turn indicators will confirm the end of the procedure.
Close the seat/top-case or remove the Green/Brown wire from ground and insulate.
!
ATTENTION – The alarm memory will only store 8 devices; saving an extra device (9) will
automatically delete the first device.
B/ Learn a new device without the alarm Green/Brown wire:
Arm and then dis-arm the alarm system via the original alarm remote control or electronic key.
Turn ignition key to 'ON'.
The alarm LED will turn ON for 1 second.
While the alarm LED is ON, simultaneously press both buttons on the remote control or insert the electronic
touch key into its receptacle.
Two flashes of the turn indicators and two beeps (high and low) will confirm the system is in learning mode.
Depending on which device is to be learned either press one of the new remote control buttons OR insert the
electronic key in its receptacle OR make the magnetic contact transmit of the wireless reed switch to be learnt
(bring contact and magnet together and then move apart) OR set the Digitek G-Link garage/shed wireless PIR
to 'TX Test' (see relevant kit instructions).
A flash of the turn indicators and a high beep will confirm the operation has been completed successfully.
If another device needs to be learnt then wait 2 seconds before doing so.
To exit the learning procedure, turn ignition key 'OFF'.
A low pitched beep and a flash of the turn indicators will confirm the end of the procedure.
!
ATTENTION – The alarm memory will only store 8 devices; saving an extra device (9) will
automatically delete the first device.
1.9 – Learning New Devices
11/14
www.digitek-moto.com
Rev05/KM/271113/DigProInst
G-Line 'Pro' Alarm
System