Sony Xperia Z1 User Manual - Page 11

Browse online or download pdf User Manual for Digital Camera Sony Xperia Z1. Sony Xperia Z1 24 pages. Xperia z1
Also for Sony Xperia Z1: White Paper (24 pages), Setup Manual (2 pages), Quick Start Manual (3 pages), Test Instructions (32 pages), Calibration & Testing (8 pages), Startup Manual (15 pages)

Sony Xperia Z1 User Manual
and you don't have to lean down
middle of filming.
Never extend the legs or move the
by pulling up on the camera. All
adjustments and movements must
by holding the tripod itself. If you
the screw that holds the camera you could put massive strain on it and possibly rip the bottom out.
the post back up.
Tripod movements: The fluid head of the tripod will allow you to move the camera from side to side
(pan), up and down (tilt) and a smooth combination of the two.
You can adjust the position of the 'pan handle' by loosening and tightening the screw holding it in place
and moving it to a comfortable position for you.
Never try to pan or tilt with the locks on- this can damage the threads.
Always lock off the tripod- especially on the tilt axis- before letting go of the handle.
doing it wrong.
When the red catch 'clicks', line up the edges of the base plate with
the head of the tripod and tighten the screw-catch.
If you need more height, you can use the large catches on each leg at
the top or bottom. It is easier to adjust the top catches, so always
extend the bottom ones first. That way you can do small adjustments
Once you have your height right, look at the head of the tripod.
At the top of the legs there is a small circular spirit-level.
You can make sure your shot is level by reaching under the
legs and twisting the post under the head to release the 'bowl'
the head rests on. Hold the camera steady by the handle on
the top while doing this.
When you have centred the bubble in the spirit level, tighten
You can increase or decrease the 'fluid drag' on either axis-
so you can have quick, whippy loose movements or slow
steady ones.
The fluid drag control for the pan axis is underneath the base
plate.
The fluid drag control of the tilt axis is on the right of the
head just below the base plate.
You can also lock off either axis or both and have it completely
fixed.
The lock for the pan axis is behind the camera by the spirit
level.
The lock for the tilt axis is on the right hand side of the tripod.
Then slide the base plate back on.
If you can't get the red catch to
'click' as it slides on, or the base
plate sticks, try putting it on
another way. Have patience with
this part, as it is not always easy
to start with.
Do not force anything. If you
have to force anything you are
with the
top
catches
in the
tripod
tripod
be done
drag on
11