Sony Xperia Z1 Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Цифрова камера Sony Xperia Z1. Sony Xperia Z1 24 сторінки. Xperia z1
Також для Sony Xperia Z1: Біла книга (24 сторінок), Посібник з налаштування (2 сторінок), Посібник із швидкого старту (3 сторінок), Інструкція з тестування (32 сторінок), Калібрування та тестування (8 сторінок), Посібник із запуску (15 сторінок)

Друкувати сторінку

and you don't have to lean down

middle of filming.

Never extend the legs or move the

by pulling up on the camera. All

adjustments and movements must

by holding the tripod itself. If you

the screw that holds the camera you could put massive strain on it and possibly rip the bottom out.

the post back up.

Tripod movements: The fluid head of the tripod will allow you to move the camera from side to side

(pan), up and down (tilt) and a smooth combination of the two.

You can adjust the position of the 'pan handle' by loosening and tightening the screw holding it in place

and moving it to a comfortable position for you.

Never try to pan or tilt with the locks on- this can damage the threads.

Always lock off the tripod- especially on the tilt axis- before letting go of the handle.

doing it wrong.

When the red catch 'clicks', line up the edges of the base plate with

the head of the tripod and tighten the screw-catch.

If you need more height, you can use the large catches on each leg at

the top or bottom. It is easier to adjust the top catches, so always

extend the bottom ones first. That way you can do small adjustments

Once you have your height right, look at the head of the tripod.

At the top of the legs there is a small circular spirit-level.

You can make sure your shot is level by reaching under the

legs and twisting the post under the head to release the 'bowl'

the head rests on. Hold the camera steady by the handle on

the top while doing this.

When you have centred the bubble in the spirit level, tighten

You can increase or decrease the 'fluid drag' on either axis-

so you can have quick, whippy loose movements or slow

steady ones.

The fluid drag control for the pan axis is underneath the base

plate.

The fluid drag control of the tilt axis is on the right of the

head just below the base plate.

You can also lock off either axis or both and have it completely

fixed.

The lock for the pan axis is behind the camera by the spirit

level.

The lock for the tilt axis is on the right hand side of the tripod.

Then slide the base plate back on.

If you can't get the red catch to

'click' as it slides on, or the base

plate sticks, try putting it on

another way. Have patience with

this part, as it is not always easy

to start with.

Do not force anything. If you

have to force anything you are

with the

top

catches

in the

tripod

be done

drag on