Cisco Catalyst 7500 Series Configuration Manual - Page 43
Browse online or download pdf Configuration Manual for Network Hardware Cisco Catalyst 7500 Series. Cisco Catalyst 7500 Series 50 pages. Chassis interface board
Also for Cisco Catalyst 7500 Series: Datasheet (11 pages), Troubleshooting Manual (11 pages), Replacing Manual (40 pages)
Print Page
Spectralink VIEW Certified Configuration Guide: Cisco Controllers and APs
iv If present (7.4. and later versions), ensure that WPA gtk-randomize State is set
to Disable.
v
On versions before 8.3, the Fast Transition and FT PSK radio boxes must
unchecked if present. In 8.3+ versions, Adaptive may be selected from the Fast
Transition dropdown box. The Adaptive Fast Transition feature adapts to
whether the client (handset) supports Fast Transition (802.11r) roaming or not.
This allows Spectralink handsets to exist on the same SSID as clients that
support FT. However, the Adaptive mode was found to be incompatible in the
AP 3600-Series AP's.
○ For WPA-PSK, under WPA+WPA2 Parameters:
vi Select the WPA-Policy check box.
vii Select the TKIP check box for WPA Encryption.
viii At Auth Key Mgmt select PSK from the drop-down list. The PSK Format may be
selected as ASCII or HEX for both WPA-PSK and WPA2-PSK policies.
ix On versions before 8.3, the Fast Transition and FT PSK radio boxes must
unchecked if present. In 8.3+ versions, Adaptive may be selected from the Fast
Transition dropdown box. The Adaptive Fast Transition feature adapts to
whether the client (handset) supports Fast Transition (802.11r) roaming or not.
This allows Spectralink handsets to exist on the same SSID as clients that
support FT. However, the Adaptive mode was found to be incompatible in the
AP 3600-Series AP's.
x
If present (7.4. and later versions), ensure that WPA gtk-randomize State is set
to Disable.
unchecked as desired.
○ For WPA2-Enterprise (802.1X), select WPA+WPA2 Parameters:
i
Select the WPA2 Policy check box.
ii
Select the AES check box for WPA2 Encryption.
iii At Auth Key Mgmt, select 802.1X+CCKM from the drop-down list.
iv If present (7.4. and later versions), ensure that WPA gtk-randomize State is set
to Disable.
v
On versions before 8.3, the Fast Transition and FT 802.1X radio boxes must
unchecked if present. In 8.3+ versions, Adaptive may be selected from the Fast
Transition dropdown box. The Adaptive Fast Transition feature adapts to
whether the client (handset) supports Fast Transition (802.11r) roaming or not.
This allows Spectralink handsets to exist on the same SSID as clients that
support FT. However, the Adaptive mode was found to be incompatible in the
AP 3600-Series AP's.
721-1001-000-AH.docx
December 2016
The Fast Transition and FT PSK radio boxes may be checked or
43