Argo-Hytos LubMon Connect Quick Start Manual - Page 7

Browse online or download pdf Quick Start Manual for Network Router Argo-Hytos LubMon Connect. Argo-Hytos LubMon Connect 7 pages.

Print Page

4. Electrical connection

The electrical installation may only be performed by qualified professionals

(trained electricians) with the power off and in accordance with the applicable

standards and guidelines. The manufacturer will accept no responsibility in the

event of improper installation.

4.1. General, plus safety notices

Comply with national and international guidelines for setting up electrical equipment.

Power supply in accordance with EN50178, SELV, PELV, VDE0100-410/A1.

De-energise the system for the installation and connect the device as follows:

(view of connector from the outside)

Fig. 4.1: Pin assignments for the CAN interface

The permissible operating voltage is between 12V and 28 VDC. The sensor cable must be

shielded. Pin 8 und Pin 9 are for the power supply of LubMon Connect and not for the power

supply of the connected bus devices.

 Pin 1 ---

 Pin 2 CAN-L

 Pin 3 GND

 Pin 4 ---

 Pin 5 SHIELD

 Pin 6 ---

 Pin 7 CAN-H

-------- Galvanically isolated --------

 Pin 8 supply + (24VDC)

 Pin 9 supply –