Cisco SCE 1000 and Quick Start Manual - Page 12
Browse online or download pdf Quick Start Manual for Network Hardware Cisco SCE 1000 and. Cisco SCE 1000 and 49 pages. Service control engine 1000 2xgbe
Print Page
Connect the AC-Input Power Supply Unit
Plug the AC-input power cable into the AC-input power receptacle on the AC-input power supply
Step 1
For AC-input power, we recommend powering the SCE 2000 platform from a 120 VAC, 15A receptacle U.S. (240 VAC,
10A international) at the power source.
Figure 13
Connecting the AC Power
BY PA SS
1
IN
PO W ER B
OK
IN
Plug the AC power supply cable into the AC power source.
Step 2
Step 3
Turn the on/off switch to the on position.
Look at the IN and OK LEDs on the power supply unit and the corresponding Power LED on the front panel. If the
Step 4
AC-input power supply unit is operating properly, these LEDs will be glowing green.
Ensure that the power supply is properly aligned and the installation screw is tightened.
Step 5
12
PO W ER A
OK