Cisco 700 series User Manual - Page 4

Browse online or download pdf User Manual for Server Cisco 700 series. Cisco 700 series 9 pages. Using profiles
Also for Cisco 700 series: Quick Start Manual (8 pages), Overview (19 pages), Getting Started Manual (27 pages), Administration Manual (36 pages)

Print Page
Cisco 700 series User Manual
System and Profile Parameters
Table 2-2 lists the parameters that can be configured in a profile.
Table 2-2
Bridging
Ringback number
Passthrough
Learning
Subnet mask
Protocol
Loopback
Permanent Profiles
Cisco 700 series routers contain three permanent profiles. Permanent profiles can be
modified, but they cannot be deleted. The permanent profiles are as follows:
LAN
Internal
Standard
The decision to use the LAN or Internal profile involves some knowledge of your network
design and whether you are bridging or routing to remote sites (or a combination of both).
It is best to use the LAN profile instead of the Internal profile to simplify the configuration.
You can easily associate the LAN profile with the Ethernet interface and the user-defined
profiles with the ISDN interface.
Sometimes situations arise (very infrequent) where you must route a protocol to one site
and bridge the same protocol to another site. Simply leave the LAN profile as a bridging
profile, and use the Internal profile for all routed protocol information.
2-4
Cisco700 Series Router Configuration Guide
Profile Parameters
Line speed
Auto calling
Demand
Timeout
Called number
Encapsulation
Determines how data is passed from the router to the LAN. This profile
is commonly used for connections made directly to the local network.
Determines how data is passed between the bridge engine and the IP/IPX
router.
The default profile. If authentication is set to none and a profile does not
exist for the WAN switch, the router uses the Standard profile by default.
If authentication is required and no profile is found, the call is dropped.
PPP authentication (outgoing)
All IP parameters, including filters
PAP password (client and host)
All IPX parameters, including filters
CHAP secret (client and host)
Bridge filters (address, type, and user-defined)