Cisco 700 series Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Cisco 700 series. Cisco 700 series 9 pagina's. Using profiles
Ook voor Cisco 700 series: Snelstarthandleiding (8 pagina's), Overzicht (19 pagina's), Aan de slag handleiding (27 pagina's), Administratiehandleiding (36 pagina's)

System and Profile Parameters

Table 2-2 lists the parameters that can be conﬁgured in a proﬁle.

Table 2-2

Bridging

Ringback number

Passthrough

Learning

Subnet mask

Protocol

Loopback

Permanent Proﬁles

Cisco 700 series routers contain three permanent proﬁles. Permanent proﬁles can be

modiﬁed, but they cannot be deleted. The permanent proﬁles are as follows:

LAN

Internal

Standard

The decision to use the LAN or Internal proﬁle involves some knowledge of your network

design and whether you are bridging or routing to remote sites (or a combination of both).

It is best to use the LAN proﬁle instead of the Internal proﬁle to simplify the conﬁguration.

You can easily associate the LAN proﬁle with the Ethernet interface and the user-deﬁned

proﬁles with the ISDN interface.

Sometimes situations arise (very infrequent) where you must route a protocol to one site

and bridge the same protocol to another site. Simply leave the LAN proﬁle as a bridging

proﬁle, and use the Internal proﬁle for all routed protocol information.

2-4

Cisco700 Series Router Configuration Guide

Proﬁle Parameters

Line speed

Auto calling

Demand

Timeout

Called number

Encapsulation

Determines how data is passed from the router to the LAN. This proﬁle

is commonly used for connections made directly to the local network.

Determines how data is passed between the bridge engine and the IP/IPX

router.

The default proﬁle. If authentication is set to none and a proﬁle does not

exist for the WAN switch, the router uses the Standard proﬁle by default.

If authentication is required and no proﬁle is found, the call is dropped.

PPP authentication (outgoing)

All IP parameters, including ﬁlters

PAP password (client and host)

All IPX parameters, including ﬁlters

CHAP secret (client and host)

Bridge ﬁlters (address, type, and user-deﬁned)