Cisco ONS 15454 SDH Procedure Manual - Page 9

Browse online or download pdf Procedure Manual for Server Cisco ONS 15454 SDH. Cisco ONS 15454 SDH 22 pages. Install cards and fiber-optic cable

Print Page

Chapter 2 Install Cards and Fiber-Optic Cable

Table 2-3

XC Card Type

XC-VXL-2.5G

XC-VXC-10G/XC-VXL-10G

Refer to the card's reference section in the "Optical Cards" chapter of the Cisco ONS 15454 SDH

Reference Manual for more information about slot and bandwidth restrictions.

Open the card latches/ejectors.

Step 2

Use the latches/ejectors to firmly slide the optical card along the guide rails until the card plugs into the

Step 3

receptacle at the back of the slot.

Verify that the card is inserted correctly and close the latches/ejectors on the card.

Step 4

Note

Verify the LED activity:

Step 5

The red FAIL LED turns on for 20 to 30 seconds.

•

The red FAIL LED blinks for 35 to 45 seconds.

•

All LEDs blink once and turn off for 5 to 10 seconds.

•

The ACT or ACT/STBY LED turns on. The signal fail (SF) LED can persist until all card ports

•

connect to their far-end counterparts and a signal is present.

Note

If the card does not boot up properly, or the LED activity does not mimic

Step 6

When a physical card type does not match the type of card provisioned for that slot in CTC, the card

•

might not boot. If an optical card does not boot, open CTC and verify that the slot is not provisioned

for a different card type before assuming the card is faulty.

•

If the red FAIL LED does not turn on, check the power.

If you insert a card into a slot provisioned for a different card, all LEDs turn off.

•

If the red FAIL LED is illuminated continuously or the LEDs behave erratically, the card is not

•

installed properly. Remove the card and repeat Steps

78-18118-01

Maximum Bandwidth by Shelf Slot for the MRC-12 in Different Cross-Connect

Configurations

It is possible to close the latches/ejectors when the card is not completely plugged into the

backplane. Ensure that you cannot insert the card any further.

If you install the wrong card in a slot, complete the

procedure on page

2-21.

The booting STM-N card will send an AIS-L to the far-end receiver as long as it is

Locked-enabled, disabled.

NTP- D16 Install STM-N Cards and Connectors

Maximum Bandwidth in Slots 1

through 4 and 12 through 17

OC-48

"NTP-D227 Remove and Replace a Card"

to 5.

Cisco ONS 15454 SDH Procedure Guide, R8.5

Maximum Bandwidth

in Slots 5, 6, 12, or 13

OC-48

OC-192

Step

5, check the following:

2-9