Cisco S695F Getting Started Manual - Page 16

Browse online or download pdf Getting Started Manual for Server Cisco S695F. Cisco S695F 18 pages. Web security appliance
Also for Cisco S695F: Manual (24 pages), Hardware Installation Manual (50 pages)

Print Page

Configuration Summary

Item

Management

Data

Traffic Monitor

Computer

Address

Cisco Web Security Appliance S195, S395, S695, and S695F Getting Started Guide

Description

You can manage the web security appliance from the management port

(Management port) by entering http://192.168.42.42:8080 or using the IP address

assigned to the management interface after you have completed the System Setup

Wizard.

If you reset your configuration to factory default settings (for example, by

re-running the System Setup Wizard), you can access the management interface

only from the Management port (http://192.168.42.42:8080), so ensure you have

a connection to the Management port.

Also, verify that you open firewall ports 80 and 443 on your management

interface.

After running the System Setup Wizard, at least one port on the appliance is

configured to receive web traffic from the clients on the network: M1 only; M1

and P1; M1, P1 and P2; P1 only; or P1 and P2.

If you configured the web proxy in explicit forward mode, the applications

Note

on the client machines must be configured to explicitly forward web traffic

to the web security appliance's web proxy using the IP address configured

for data, either M1 or P1.

After running the System Setup Wizard, one or both L4 traffic monitor ports (T1

only or both T1 and T2) are configured to listen to traffic on all TCP ports. The

default setting for the L4 traffic monitor is monitor only. During or after setup,

you can configure the L4 traffic monitor to both monitor and block suspicious

traffic.

Remember to change your computer IP address back to the original settings that

you noted in the

"Temporarily Change Your IP Address for Remote Access"

section on page

You can review a summary of your system settings from the System

Note

Administration > Configuration Summary page.