Cisco Firepower 2600 Hardware Installation Manual - Page 36

Browse online or download pdf Hardware Installation Manual for Gateway Cisco Firepower 2600. Cisco Firepower 2600 44 pages.

Print Page

Connect Cables, Turn on Power, and Verify Connectivity

Figure 32: Inner Rail Release Clip

Inner rail release clip

Button to unlock rail

Press this button to unlock the rail so you can

pull out the chassis from the rack when

uninstalling or performing maintenance.

Step 5

(Optional) Secure the chassis in the rack more permanently by using the two screws that are provided with the slide rails.

Perform this step if you plan to move the rack with chassis installed. With the chassis fully pushed into the slide rails,

open a hinged slam latch lever on the front of the chassis and insert the screw through the hole that is under the lever.

The screw threads into the static part of the rail on the rack post and prevents the chassis from being pulled out. Repeat

for the opposite slam latch.

What to do next

Continue with

Connect Cables, Turn on Power, and Verify Connectivity

This procedure references the rear panel ports of the FMC 2600 and 4600. The FMC 1600 is the same except

that it does not have the two 10-G SFP+ ports above the Ethernet ports.

After rack mounting the chassis, follow these steps to connect cables, turn on power, and verify connectivity.

Note

AC power supplies have internal grounding and so no additional chassis grounding is required when the

supported AC power cords are used. For more information about supported power cords, see

Specifications, on page

Note

Although the CIMC is not supported on the FMC, you can use LOM on the default management interface

(eth0) on a SOL connection to remotely monitor or manage the FMC system. For information about using

LOM and SOL, see the

and 4600

Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide

Connect Cables, Turn on Power, and Verify Connectivity, on page

14.

Cisco Firepower Management Center Getting Started Guide for Models 1600, 2600,

for your model.

Inner rail attached to the chassis and inserted

into outer rail

Outer rail attached to rack post

Mount and Connect

32.

Power Cord