Cisco Linksys WAG200G User Manual - Page 9

Browse online or download pdf User Manual for Gateway Cisco Linksys WAG200G. Cisco Linksys WAG200G 39 pages. Linksys wireless-g adsl home gateway

Print Page

1. Setup > Basic Setup

Chapter4

or data traffic; UBR (Unspecified Bit Rate) for applications

that are not time-sensitive, such as e-mail; or VBR (Variable

Bit Rate) for bursty traffic and bandwidth-sharing with

other applications.

NOTE:

If the QoS Type setting is CBR, then the SCR

Rate is not configurable. If the QoS Type setting

is UBR, then the PCR and SCR Rate settings are

not configurable.

PCR Rate

For the Peak Cell Rate (PCR), divide the DSL line

rate by 424 to get the maximum rate the sender can send

cells. Enter the rate in the field (if required by your service

provider).

SCR Rate

The Sustain Cell Rate (SCR) sets the average cell

rate that can be transmitted. The SCR value is normally

smaller than the PCR value. Enter the rate in the field (if

required by your service provider).

Autodetect

Select Enable to have the VPI/VCI settings

automatically detected, or select Dsable to enter the

values manually.

Vrtual Crcut

These fields consist of two items: VPI

(Virtual Path Identifier) and VCI (Virtual Channel Identifier).

Enter the settings provided by your ISP.

DSL

Modulaton

Select

MultMode, T1.13, G.dmt, G.lte, ADSL2, or ADSL2+.

Contact your ISP if you are not sure which mode to use.

Follow the instructions for your type of encapsulation.

RFC 2364 PPPoA

Some DSL-based ISPs use PPPoA (Point-to-Point Protocol

over ATM) to establish Internet connections. If you are

connected to the Internet through a DSL line, check with

your ISP to see if they use PPPoA. If they do, you will have

to enable PPPoA.

Internet Connection Type > RFC 2364 PPPoA

Wreless-G ADSL Home Gateway

the

appropriate

mode:

Advanced Configuration

PPPoA Settings

Username and Password

Password provided by your ISP.

Connect on Demand: Max Idle Tme

the Gateway to cut the Internet connection after it has

been inactive for a specified period of time (Max Idle Time).

If your Internet connection has been terminated due to

inactivity, Connect on Demand enables the Gateway to

automatically re-establish your connection as soon as you

attempt to access the Internet again. To use this option,

select Connect on Demand. In the Max Idle Time field,

enter the number of minutes you want to have elapsed

before your Internet connection terminates. The default

Max Idle Time is minutes.

Keep Alve: Redal Perod

the Gateway will periodically check your Internet

connection. If you are disconnected, then the Gateway

will automatically re-establish your connection. To

use this option, select Keep Alve. In the Redial Period

field, specify how often you want the Gateway to check

the Internet connection. The default Redial Period is

30 seconds.

NOTE:

For

New

instructions:

Select

RFC

Encapsulation drop-down menu.

For the Virtual Circuit ID, enter 0 for the VPI

and 100 for the VCI.

Select VC for Multiplexing.

Select Multmode from the DSL Modulation

drop-down menu.

Obtain the User Name and Password details

from your ISP.

RFC 2516 PPPoE

Some DSL-based ISPs use PPPoE (Point-to-Point Protocol

over Ethernet) to establish Internet connections. If you are

connected to the Internet through a DSL line, check with

your ISP to see if they use PPPoE. If they do, you will have

to enable PPPoE.

Enter the User Name and

You can configure

If you select this option,

Zealand,

these

PPPoA

from

the