Acuity Controls rPODB Installation Instructions

Browse online or download pdf Installation Instructions for Switch Acuity Controls rPODB. Acuity Controls rPODB 2 pages.

Print Page
Installation Instructions - rPODB Wireless Switch
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
!
WARNING! RISK OF SEVERE INJURY OR DEATH
To reduce the risk of death, injury or property damage from fire, electric shock, cuts, abrasions, falling parts, and other hazards:
•
Read all warnings and instructions included with and on the fixture box and all fixture labels.
•
Installation and service should be performed by a qualified licensed electrician.
•
Maintenance must be performed by a person familiar with the construction and operation of this product and any hazards involved.
All applicable codes and ordinances must be followed.
•
Read this document before installing, servicing, or maintaining this equipment. These instructions do not cover all installation,
service, and maintenance situations. If your situation is not covered, or if you do not understand these instructions or additional
information is required, contact
!
WARNING! RISK OF ELECTRIC SHOCK
Before installing, servicing, or maintaining this equipment, follow these general precautions.
To reduce the risk of electrocution:
!
WARNING! RISK OF FIRE
To reduce the risk of fire:
!
WARNING! RISK OF PERSONAL INJURY
To reduce the risk of personal injury from cuts, abrasions:
!
WARNING! RISK OF PRODUCT DAMAGE
Electrostatic Discharge (ESD) will damage electronic equipment. Do not attempt to open or service electronic equipment without proper ESD
precautions.
Acuity Controls assumes no responsibility for claims arising out of improper or careless installation or handling of this product. Failure to
For a complete listing of product Terms and Conditions, please visit www.AcuityControls.com
Always read complete installation instructions prior to installation!
Acuity Brands | One Lithonia Way Conyers, GA 30012 Phone: 800.535.2465 www.acuitycontrols.com © 2016 Acuity Brands Lighting, Inc. All rights reserved. 07/19/16
READ AND FOLLOW ALL SAFETY INSTRUCTIONS!

IMPORTANT SAFETY INSTRUCTIONS

Acuity Controls.
•
Disconnect or turn off power before installation or servicing.
•
Make sure the equipment is properly grounded.
•
Make all electrical connections in accordance with the National Electrical Code (NEC) and any applicable local code
requirements.
•
Use supply conductors with a minimum operating temperature rating as specified.
•
Do not exceed maximum wattage, ratings, or published operating conditions.
•
Follow all manufacturer's warnings, recommendations and restrictions to ensure proper operation.
•
Wear gloves and safety glasses at all times when installing, servicing or performing maintenance.
•
Do not touch electronic components. ESD damage can occur.
•
Do not change or alter internal wiring or circuitry.
follow any of these instructions could void product warranty.

SAVE THESE INSTRUCTIONS

1 of 2