Acuity Controls rPODB Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Switch Acuity Controls rPODB. Acuity Controls rPODB 2 pages.

Print Page
Installation Instructions - rPODB Wireless Switch
The rPODB is a wireless switch that can be interconnected with the nLight® AIR network of wireless sensors and switches.
INSTALLATION:
Installation of the rPODB wall switch is simple, straight forward, and quick! Designed as truly "wire-free" with embedded wireless and battery power, installation requires zero wiring.
Follow the simple steps below to perform the mechanical installation of the rPODB Wall Switch.
•
No wiring needed!
•
Install the rPODB into a single gang box just like your typical wall switch
•
Can be installed retainer first, or switch and retainer together
•
Check to make sure the rPODB is secure in retainer clip once installed
•
Screw down wall plate
•
DONE!
Battery Replacement:
•
Remove wall plate.
•
Carefully pry the retainer clip away from the module while pulling the rPODB from the retainer housing.
- Using a flat head screwdriver, carefully pry the retainer clip away from the module. Use the tip of the screwdriver to pry against the tab on the module to
help remove the rPODB module from the retainer clip. Otherwise, simply unscrew the retainer and module together from the gang box, then separate
the module from the retainer.
•
Remove the battery cover with a short slide of the door, then lift battery cover off.
- Note the arrow on the battery cover for direction to slide cover, also the ridges on the side for finger grips.
•
Remove old batteries and replace with new ones.
•
Reinstall battery cover by aligning the battery cover line with the line on the on the module, then slide shut.
•
Reinstall the rPODB Module into the retainer until secured
•
Reinstall wall plate
•
Done!
Alignment Line
!
CAUTION - To Reduce Risk of Fire. Use only Energizer L92 lithium batteries or any size AAA batteries of Type Zinc-Carbon, Alkaline, or Nickel-Cadmium
CAUTION - The cell used in this device may present a fire or chemical burn hazard if mistreated. Do not disassemble, heat above 100°C (212°F) or incinerate.
Dispose of used cell promptly. Keep away from children.
912-0018-001
Acuity Brands | One Lithonia Way Conyers, GA 30012 Phone: 800.535.2465 www.acuitycontrols.com © 2016 Acuity Brands Lighting, Inc. All rights reserved. 07/19/16
rPODB Basic Overview
Mounting Instructions/Important Notes
Retainer Clip
2 of 2