Motorola CP 140 User Manual - Page 11

Browse online or download pdf User Manual for Two-Way Radio Motorola CP 140. Motorola CP 140 26 pages. Uhf2 (438-470mhz)
Also for Motorola CP 140: Basic User's Manual (16 pages), Basic User's Manual (16 pages), Basic User's Manual (18 pages), Detailed Service Manual (28 pages), Cps/Tuner Installation Manual (6 pages), Service Information (46 pages), Service Information (46 pages)

Motorola CP 140 User Manual

GETTING STARTED

BATTERY INFORMATION

Charging Your Battery

This radio is powered by a either a nickel-metal
hydride (NiMH), or a lithium-ion (Li-lon)
rechargeable battery. Charge the battery before use
to ensure optimum capacity and performance. The
battery was designed specifically to be used with a
Motorola charger. Charging in non-Motorola
equipment may lead to battery damage and void the
battery warranty.
Note: When charging a battery attached to a radio,
turn the radio off to ensure a full charge.
The battery should be at about 25°C (77°F) (room
temperature), whenever possible. Charging a cold
battery (below 10°C [50°F]) may result in leakage of
electrolyte and ultimately in failure of the battery.
Charging a hot battery (above 35°C [95°F]) results
in reduced discharge capacity, affecting the
performance of the radio. Motorola rapid-rate
battery chargers contain a temperature-sensing
circuit to ensure that batteries are charged within the
temperature limits stated above.
If a battery is new, or its charge level is very low, you
will need to charge it before you can use it. When
the battery level is low and the radio is in transmit
mode you will see the LED indicator flash red. Upon
release of the PTT button, you will hear an alert
tone.
Note: Batteries are shipped uncharged from the
factory. Always charge a new battery 14 to 16
hours before initial use, regardless of the
status indicated by the charger.
English
9