SCAN
Your radio is equipped with the Scan feature, which
allows you to monitor multiple channels for voice
activity. The radio will stop on a channel when it
detects activity on it.
Scan lists are assigned per channel, by your dealer/
programmer. Your radio automatically switches to a
channel, within that scan list, when it detects activity.
•
The LED indicator blinks green during scan
mode; it stops blinking when the radio switches
to an active channel.
There are two types of Scan available in your radio:
•
System Scan
•
Auto Scan
START SYSTEM SCAN
Press the preprogrammed Scan button to start scan.
STOP SYSTEM SCAN
Press the preprogrammed Scan button to stop
System Scan.
Note: Your dealer/programmer can preprogram
your radio when exiting System Scan to
automatically revert to the last scan channel
that had activity on it or to automatically revert
to the channel where scan was initiated.
START AUTO SCAN
Auto Scan automatically starts scanning once a
channel with Auto Scan enabled is selected.
Select a channel that has been preprogrammed for
Auto Scan by your dealer/programmer.
STOP AUTO SCAN
Select a channel that has not been preprogrammed
for Auto Scan by your dealer/programmer.
TALKBACK
The Talkback feature allows you to respond to a
transmission while scanning. If transmission is
detected on a channel while scanning, the radio will
stop on that channel for a default period of time
after activity has ceased. This is referred to as
"hangtime". During this hangtime you may respond
by pressing the PTT button.
Note: The LED scan indicator stops blinking while
the radio is in hangtime. If the PTT button is
not pressed after the preprogrammed
hangtime, the radio returns to scanning
channels.
English
21
Print Page