Motorola ASTRO Digital XTS 3000 Basic Service Manual - Page 34
Browse online or download pdf Basic Service Manual for Radio Motorola ASTRO Digital XTS 3000. Motorola ASTRO Digital XTS 3000 48 pages. Handheld radio
Also for Motorola ASTRO Digital XTS 3000: Operator's Manual (12 pages)
Print Page
Volume Knob
Removing the
Volume Knob
Installing the
Volume Knob
24
2. Align the lightpipe (5) so that its straight tab is over the slot for the
illuminated pointer. Push the tab down into the slot so that it is securely
seated.
3. Place the secure lever (4) on the frequency control shaft, aligning it so that
its pointer is at the front of the radio and its two inner slots line up with
the two keys on the shaft. Slide the secure lever down to the bottom of the
shaft.
4. If you are replacing the escutcheon (2), remove the backing paper from
the escutcheon, align its alignment marker with the alignment notch
(between numbers 4 and 5) on the insert, and adhere it to the insert.
5. Place the frequency insert (3) and escutcheon (2) on the frequency control
shaft, aligning the insert's D-shaped hole with the D-shaped shaft. Press
downward firmly on the insert until it "snaps" in place on the shaft.
6. Place the frequency knob (1) on the frequency insert (3), aligning it's
pointer with the number "1" on the escutcheon (2). Press firmly
downward on the knob until it seats securely in place.
NOTES:
•
Refer to Figure 8, the Partial Exploded View, and Table 12, the
Partial Exploded View Parts List. Numbers in parentheses ( ) refer to
item numbers in Figure 8 and Table 12.
•
The battery (7) should be removed from the radio before installing
or removing the volume knob (8).
1. Hold the radio in one hand so that the top of the radio faces upward, and
the front of the radio faces you.
2. With the other hand, grasp the volume knob (8) and pull it upward, while
pushing it toward the back of the radio, until it is free from the volume
insert (9).
3. While pressing the volume insert's (9) two snap tabs away from the
volume control shaft so that the insert disengages from the shaft, use
needle-nosed pliers to pull the insert up and off of the volume control
shaft.
4. Using needle-nosed pliers or some other pointed instrument, remove the
o-ring (21).
1. Place the o-ring (21) inside the volume insert (9), and press it downward
until it seats securely at the bottom of the insert.
2. Hold the radio so that the top of the radio faces upward, and the front of
the radio faces you.
3. Place the volume insert (9) on the volume control shaft, aligning its D-
shaped hole with the D-shaped shaft. Press downward firmly on the insert
until it "snaps" in place on the shaft.
4. Place the volume knob (8) on the volume insert (9), aligning the two lugs
on the inside of the knob with the insert's two snap tabs. Press firmly
downward on the knob until it seats securely in place.