Epson 1815p - PowerLite XGA LCD Projector User Manual - Page 25

Browse online or download pdf User Manual for Software Epson 1815p - PowerLite XGA LCD Projector. Epson 1815p - PowerLite XGA LCD Projector 27 pages. Release of check tool for network projectors v1.00 for windows
Also for Epson 1815p - PowerLite XGA LCD Projector: User Manual (42 pages), Operation Manual (36 pages), Operation Manual (47 pages), Quick Setup (2 pages), User Manual (1 pages), Function Manual (5 pages), Software Manual (2 pages), Declaration Of Conformity (4 pages), Parts List (1 pages), Product Support Bulletin (45 pages), Product Support Bulletin (25 pages), Product Support Bulletin (22 pages), Product Support Bulletin (28 pages), Product Support Bulletin (41 pages), Product Support Bulletin (34 pages), Product Support Bulletin (28 pages), Product Support Bulletin (15 pages), Product Support Bulletin (22 pages)

Print Page

Epson 1815p - PowerLite XGA LCD Projector User Manual

Replacing the Lamp and Air Filter

The life span of the projection lamp is about 2,500 hours if

in the Settings menu is set to

Brightness Control

(default), and 3,000 hours if

It is time to replace the lamp when:

❏ The projected image gets darker or starts to deteriorate.

❏ The message

Replace the lamp

the lamp comes on and the lamp warning light

orange. To maintain projector brightness and image quality,

replace the lamp as soon as possible.

❏ The lamp warning light

out).

Lamp

warning

light

Follow these steps to replace the lamp and air filter:

1. Turn off the projector and unplug the power cord.

2. Let the projector cool for at least an hour (if it has been on).

The lamp is extremely hot immediately after use.

3. Loosen the lamp cover screw (you don't need to remove it).

Then slide the lamp cover to the side and lift it off the

projector.

High

is set to

Brightness Control

appears on the screen when

flashes

flashes red (the lamp is burnt

4. Loosen the two screws holding the lamp in place (you can't

remove them).

Low

5. Hold the lamp as shown and pull it straight out.

6. Gently insert the new lamp. (If it doesn't fit easily, make sure

it is facing the right way.)

7. Once the lamp is fully inserted, tighten its screws.

8. Replace the lamp cover, then tighten its screw.

9. Slide out the air filter on the bottom of the projector and

remove it.

10.Slide in the new air filter until it clicks in place.

11.Reset the lamp timer as described in the next section.

Note: When you get a replacement lamp for your projector, you

should replace the filter. Turn off this product when not in use to

prolong the life of the projector.

3/08

PowerLite 1810p/1815p

Loosen, but don't

remove these screws

PowerLite 1810p/1815p