Epson Perfection 3200 Product Support Bulletin - Page 28

Browse online or download pdf Product Support Bulletin for Software Epson Perfection 3200. Epson Perfection 3200 40 pages. Scanning application force quits on mac os 10.4
Also for Epson Perfection 3200: Product Support Bulletin (34 pages), Product Information (6 pages), Safety And Warranty Manual (8 pages), Start Manual (8 pages), Software Manual (34 pages), Product Support Bulletin (23 pages), Product Support Bulletin (24 pages), Product Support Bulletin (29 pages), Product Support Bulletin (8 pages), Product Support Bulletin (3 pages), Product Support Bulletin (14 pages), Product Support Bulletin (18 pages), Product Support Bulletin (12 pages), Product Support Bulletin (40 pages), Product Support Bulletin (11 pages), Product Support Bulletin (40 pages), Product Support Bulletin (22 pages), Product Support Bulletin (12 pages), Product Support Bulletin (21 pages)

Print Page
Epson Perfection 3200 Product Support Bulletin
Clicking on "Refresh List" brings up this Warning window again.
Solution:
Download the patch from Epson's Support Web site at http://support.epson.com. The Installer should find the location of
your Epson Smart Panel software and install the update automatically.
Run Setup.exe and the Install wizard will find the location of Epson Smart Panel software on your hard drive and prompt
you to continue. Click "Next." The Install wizard will then finish. Click "Finish" to complete the update and exit.
To verify the patch was successful, open Epson Smart Panel and click on the Light bulb icon in the upper left-hand
corner. Select "About" from the pull-down menu. You should see v.2.01P01E (see figure below).
Start the Scan to Email Utility and run through the steps again. You will now find that your Email Program shows up as a
registered application in the Launch Assistant window (see figure below).
After you select your Email Program, it will open with a "Compose New" window and your scanned file will be attached
to the Email. Enter an email address, a subject line, and some text in the body of the mail, and then click "Send".