Epson Perfection 3200 Ürün Destek Bülteni - Sayfa 28

Yazılım Epson Perfection 3200 için çevrimiçi göz atın veya pdf Ürün Destek Bülteni indirin. Epson Perfection 3200 40 sayfaları. Scanning application force quits on mac os 10.4
Ayrıca Epson Perfection 3200 için: Ürün Destek Bülteni (34 sayfalar), Ürün Bilgileri (6 sayfalar), Güvenlik ve Garanti Kılavuzu (8 sayfalar), Başlangıç Kılavuzu (8 sayfalar), Yazılım Kılavuzu (34 sayfalar), Ürün Destek Bülteni (23 sayfalar), Ürün Destek Bülteni (24 sayfalar), Ürün Destek Bülteni (29 sayfalar), Ürün Destek Bülteni (8 sayfalar), Ürün Destek Bülteni (3 sayfalar), Ürün Destek Bülteni (14 sayfalar), Ürün Destek Bülteni (18 sayfalar), Ürün Destek Bülteni (12 sayfalar), Ürün Destek Bülteni (40 sayfalar), Ürün Destek Bülteni (11 sayfalar), Ürün Destek Bülteni (40 sayfalar), Ürün Destek Bülteni (22 sayfalar), Ürün Destek Bülteni (12 sayfalar), Ürün Destek Bülteni (21 sayfalar)

Sayfayı Yazdır
Epson Perfection 3200 Ürün Destek Bülteni
Clicking on "Refresh List" brings up this Warning window again.
Solution:
Download the patch from Epson's Support Web site at http://support.epson.com. The Installer should find the location of
your Epson Smart Panel software and install the update automatically.
Run Setup.exe and the Install wizard will find the location of Epson Smart Panel software on your hard drive and prompt
you to continue. Click "Next." The Install wizard will then finish. Click "Finish" to complete the update and exit.
To verify the patch was successful, open Epson Smart Panel and click on the Light bulb icon in the upper left-hand
corner. Select "About" from the pull-down menu. You should see v.2.01P01E (see figure below).
Start the Scan to Email Utility and run through the steps again. You will now find that your Email Program shows up as a
registered application in the Launch Assistant window (see figure below).
After you select your Email Program, it will open with a "Compose New" window and your scanned file will be attached
to the Email. Enter an email address, a subject line, and some text in the body of the mail, and then click "Send".