CRU Forensic Labdock S5 User Manual - Page 3
Browse online or download pdf User Manual for Storage CRU Forensic Labdock S5. CRU Forensic Labdock S5 10 pages.
Print Page
3
Forensic LabDock S5 and U5 User Manual
REAR OF THE S5 FLDs MODEL
SATA Data Connector
For Front SATA/IDE
Connections
Power Connector
FRONT OF THE U5 MODEL
Error
USB Write-Block
Indicator
Status LED
USB
Write-Blocked
Remount
USB Connector
Button
Power Fail
Fan Fail
HPA/DCO
Indicator
Indicator
Indicator
Molex
power connector
REAR OF THE U5 MODEL
SATA Data Connector
For Front SATA/IDE
Connections
Power Connector
Protecting Your Digital Assets
SATA & PATA
Firmware
Configuration Port
SAS Pass-through
Data Connector to
RedPort HBA Card
Write-Blocked
Drive
IDE Connector
Activity LED
IDE/SATA
Power
Write-Block
Status LED
Hard Drive
Power
Cubby
Switch
Write-Blocked
eSATA Connector
SATA & PATA
Firmware
Configuration Port
Write-Blocked USB
Pass-through Connector
TM
1.3 LED BEHAVIOR
LED
Power
Drive Activity
Error
Indicator
Power Fail
Indicator
HPA/DCO
Indicator
Fan Fail
LED
Indicator
USB Write-
Block Status
IDE/SATA
Write-Block
Status
* This LED appears only on the Forensic LabDock U5.
1.4 WARNINGS AND NOTICES
Please read the following before beginning installation.
General Care
•
The main circuit board of the Forensic LabDock is sus-
ceptible to static electricity. Proper grounding is strongly
recommended to prevent electrical damage to the enclo-
sure or other connected devices, including the computer
host. Avoid all dramatic movement, tapping on the unit,
and vibration.
•
Avoid placing the hard drives close to magnetic devices,
high voltage devices, or near a heat source. This includes
any place where the product will be subject to direct
sunlight. Do NOT allow water to make contact with the
drive or the Forensic LabDock.
COLOR
STATE
DESCRIPTION
The Forensic LabDock
Green
Solid
is powered on.
Solid or
The attached drive is
Amber
Blinking
being accessed.
The attached drive has
reached 131°F/55°C,
Red
Solid
or an HPA/DCO-related
disk command has
failed.
There is a problem with
either the +5V or +12V
Red
Solid
power output to the
attached drive.
An HPA or DCO area
has been detected.
Amber
Solid
Once lit, it will not be
unlit until the LabDock's
power is cycled.
The cooling fan has
stopped working and
Red
Solid
needs replaced. Please
contact CRU Technical
Support.
The attached USB de-
Amber
Solid
vice is write-blocked.
The attached IDE or
Amber
Solid
SATA drive is write-
blocked.
*