Pioneer AVX-7300 Installation Manual

Browse online or download pdf Installation Manual for Car Receiver Pioneer AVX-7300. Pioneer AVX-7300 6 pages. Pioneer avx-7300 car audio video system
Also for Pioneer AVX-7300: Operation Manual (28 pages), Installation Manual (14 pages), Installation Manual (6 pages)

Print Page

AVX-7300

This product conforms to CEMA cord colors.

Le code de couleur des câbles utilisé pour ce produit est

conforme à CEMA.

Printed in Japan

Imprimé au Japon

<CRD3482-A> UC

Connecting the Units

Note:

• This unit is for vehicles with a 12-volt battery and

• If this unit is installed in a vehicle that does not

negative grounding. Before installing it in a recre-

have an ACC (accessory) position on the ignition

ational vehicle, truck, or bus, check the battery

switch, the red lead of the unit should be connected

voltage.

to a terminal coupled with ignition switch ON/OFF

• To avoid shorts in the electrical system, be sure to

operations. If this is not done, the vehicle battery

disconnect the ≠ battery cable before beginning

may be drained when you are away from the vehi-

installation.

cle for several hours. (Fig.1)

• Refer to the owner's manual for details on

connecting the power amp and other units, then

make connections correctly.

• Secure the wiring with cable clamps or adhesive

tape. To protect the wiring, wrap adhesive tape

around them where they lie against metal parts.

• Route and secure all wiring so it cannot touch any

moving parts, such as the gear shift, handbrake and

ACC position

No ACC position

seat rails. Do not route wiring in places that get

hot, such as near the heater outlet. If the insulation

of the wiring melts or gets torn, there is a danger of

the wiring short-circuiting to the vehicle body.

• Don't pass the yellow lead through a hole into the

engine compartment to connect to the battery. This

• Cords for this product and those for other products

will damage the lead insulation and cause a very

may be different colors even if they have the same

dangerous short.

function. When connecting this product to another

• Do not shorten any leads. If you do, the protection

product, refer to the supplied Installation manuals

circuit may fail to work when it should.

of both products and connect cords that have the

• Never feed power to other equipment by cutting

same function.

the insulation of the power supply lead of the unit

and tapping into the lead. The current capacity of

the lead will be exceeded, causing overheating.

• When replacing fuse, be sure to use only fuse of

the rating prescribed on the fuse holder.

• If the RCA pin jack on the unit will not be used, do

not remove the caps attached to the end of the con-

nector.

Connecting the Power Cord

Fig. 1

Yellow (video input)

(VIDEO INPUT)

Orange/white

To lighting switch terminal.

Red

To electric terminal controlled by ignition

switch (12 V DC) ON/OFF.

Yellow

To terminal always supplied with power

regardless of ignition switch position.

Black (ground)

To vehicle (metal) body.

This Product

Light green

Used to detect the ON/OFF status of the parking brake.

This lead must be connected to the power supply side

of the parking brake switch.

15 cm

Power supply side

Ground side

Fuse resistor

Fuse holder

Connection method

Clamp the parking brake

switch power supply side

lead.

2. Clamp firmly with

needle-nosed pliers.

Note:

• The position of the parking brake switch depends

on the vehicle model. For details, consult the

vehicle Owner's Manual or dealer.

Parking brake switch

Fig. 2