Pioneer AVX-7300 Installation Manual - Page 3
Browse online or download pdf Installation Manual for Car Receiver Pioneer AVX-7300. Pioneer AVX-7300 6 pages. Pioneer avx-7300 car audio video system
Also for Pioneer AVX-7300: Operation Manual (28 pages), Installation Manual (14 pages), Installation Manual (6 pages)
Print Page
Installation
2. Install side brackets. (Fig. 7)
Side bracket
Flush surface screw (5 × 6 mm)
3. Fastening the unit. (Fig. 8)
As a rule, secure with side brackets (large).
Holder
After inserting the holder into the dash-
board, then select the appropriate tabs
according to the thickness of the dash-
Dashboard
board material and bend them.
(Install as firmly as possible using the
182
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
53
Rubber bush
Screw
Attach screw
Side bracket
(large)
7 When the installation space is not very deep
When installing in a shallow space, secure with side brackets (small). In this case, stick
conceal tape on parts that protrude from the dashboard.
Holder
After inserting the holder into the dash-
board, then select the appropriate tabs
according to the thickness of the dash-
Dashboard
board material and bend them.
(Install as firmly as possible using the
182
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
53
Rubber bush
Screw
Fig. 7
Side bracket
(small)
DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 10)
Frame
Pull out to remove the frame.
Fig. 8
(When reattaching the frame, point the
side with a groove downwards and
attach it.)
2. Fastening the unit to the factory radio mounting bracket.
(Fig. 11) (Fig. 12)
Select a position where the screw holes of the bracket and the screw holes of this product
become aligned (are fitted), and tighten the screws at 2 places on each side. Use any of bind-
ing screws (4 × 3 mm), binding screws (5 × 6 mm) or flush surface screws (5 × 6 mm),
depending on the shape of the screw holes in the bracket.
*1 Use binding screws (4 × 3 mm) only.
Conceal tape
Attach screw
Fig. 9
Factory radio mounting bracket
Fig. 10
Installing the Voice Guidance Speaker
Precaution:
• Do not install on the dashboard where it may be subjected to direct sunlight. High temperatures may
result in damage to the unit.
• Install within the transmission range of the remote control signal.
Stick the supplied velcro tapes to both the back of the voice guidance speaker and center
console, and attach them.
* 1
* 1
Fig. 11
Screw
11
Dashboard or Console
13
12
Fig. 12
<ENGLISH>
Voice guidance speaker
Velcro tape
(rough surface)
Velcro tape
(soft surface)
Fig. 13