Pioneer DEH-3200UB Operation Manual - Page 29
Browse online or download pdf Operation Manual for Car Receiver Pioneer DEH-3200UB. Pioneer DEH-3200UB 31 pages. Cd rds receiver
Also for Pioneer DEH-3200UB: Installation Manual (6 pages), Operation Manual (28 pages), Operation Manual (29 pages), Installation Manual (8 pages)
Print Page
C--..:cI-=-=-n-=-st:.cca:.::..:l1-=..::a-=..::t i-=-o-=-=-n
~)
C~
E_n-",-9_li_sh~)
C Installation
)
C
---=En:..:..;9;LI::..:c is =..h)
Screw
Fastening the front panel
If you do not plan to detach the front panel,
the front pane! can be fastened with supplied
screw.
Releasing the front panel allows easier access
to the trim ring
2. Insert the supplied extraction keys
into both sides of the unit until
they click into place.
3. Pull the unit out of the dashboard.
Removing the Unit
1. Extend top and bottom of the trim
ring outwards to remove the trim
ring. (When reattaching the trim
ring, point the side with the groove
down.)
Make sure that the unit is installed securely
in place. Unstable installation may cause this
unit to malfunction. such as sound skip.
Screw (M4 x 8)
Use either truss (5 mm x 8 mm) or flush
surface (5 mm x 9 mm) screws. depending
on the bracket screw holes.
____ Nut
~Firewallor
metal support
Factory radio mounting bracket
2. Tighten two screws on each side.
Screw
3. Install the unit as illustrated.
Use commercially available parts when
installing
DIN
Rear-mount
1. Determine the appropriate position
where the holes on the bracket and
the side of the unit match.
2. Secure the mounting sleeve by
using a screwdriver to bend the
metal tabs (90') into place.
Mounting sleeve
DIN
Front-mount
1. Insert the mounting sleeve into the
dashboard.
• When installing in a shallow space. use a
supplied mounting sleeve. If there is enough
space behind the unit. use factory supplied
mounting sleeve
DIN
Front/Rear-mount
This unit can be properly installed either from
"Front" (conventional DIN Front-mount) or
"Rear" (DIN Rear·mount installation, utilizing
threaded screw holes at the Sides of unit
chassis). For details, refer to the following
installation methods.
II
Note
Check all connections and systems before final
installation,
Do not use unauthorized parts, The use of
unauthorized parts may cause malfunctions.
Consull with your dealer if Installation requires
drilling of holes or other modifications of the
vehicle
Do not install this unit where:
-it
may interfere with operation of the vehicle.
- it may cause injury to a passenger as a result of
a sudden stop.
The semiconductor laser will be damaged
if
it
overheats. Install this unit away from hot places
such as near the healer outlet.
Optimum performance is obtained when the unit
is installed at an angle
of
less than 60°.