Pioneer XV-DV232 Operating Instructions Manual - Page 38

Browse online or download pdf Operating Instructions Manual for Receiver Pioneer XV-DV232. Pioneer XV-DV232 44 pages. Dvd/cd receiver & speaker system

Print Page

Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is

something wrong with this component, check the points below. Sometimes the trouble may lie in

another component. Investigate the other components and electrical appliances being used. If the

trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer

authorized service center or your dealer to carry out repair work.

• If the system does not operate normally due to external effects such as static electricity

disconnect the plug from the outlet and insert again to return to normal operating conditions.

General

Problem

The power does not

turn on, or switches off

suddenly (an error

message may be

displayed at startup).

No sound is output

when a function is

selected.

No image is output

when playing discs.

No sound from

surround or center

speakers.

Can't operate the

remote control.

SND DEMO shows in

the display and the unit

can't be controlled.

Remedy

• Leave the unit plugged in, wait for one minute, then switch back on.

• Make sure there are no loose strands of wire touching the unit. This could

cause the system to shut off automatically.

• Check that the speakers are connected correctly.

• Make sure the voltage of the mains power source is correct for the model.

• Try reducing the volume level.

• If the problem persists, take it to your nearest Pioneer authorized service

center or your dealer for servicing.

• If you're using the line input, make sure the component is connected

correctly (see Connecting auxiliary components on page 26).

MUTE

• Press

on the remote control to turn muting off.

• Make sure the TV is connected correctly (refer to the Setup Guide).

• Australian model only – Reset the video output to interlace (see Video

Output settings on page 21).

• Refer to Setting the channel levels on page 6 to check the speaker levels.

• When TUNER or LINE is selected, you can only hear the source in stereo.

Switch the input source to DVD/CD for multichannel sound.

• Check that the Recording mode hasn't been switched on (see Recording

mode on page 27).

• Check that you haven't selected the STEREO mode (see Listening in

surround sound on page 11).

• Connect the speakers properly (refer to the Setup Guide).

• Replace the batteries (refer to the Setup Guide).

• Operate within 7 m, 30° of the remote sensor (refer to the Setup Guide).

• Remove any obstacles or operate from another position.

• Avoid exposing the remote sensor on the front panel to direct light.

• Press and hold

(stop) on the front panel for about ﬁve seconds. The disc

tray ejects automatically to indicate the Sound Demo mode is disabled.