Pioneer XV-DV232 Operating Instructions Manual - Page 40

Browse online or download pdf Operating Instructions Manual for Receiver Pioneer XV-DV232. Pioneer XV-DV232 44 pages. Dvd/cd receiver & speaker system

Print Page
09
Additional information

Tuner

Problem
Considerable noise in
radio broadcasts.
Auto tuning does not
pick up some stations.

Error Messages

Message
REC MODE
SND DEMO
CANNOT
STEREO
TRAY LOCK
MUTING
EEP ERROR
EXIT

Resetting the system

Use this procedure to reset all system settings
to the factory default.
1
Switch the system on.
2
Press
STANDBY/ON while holding
down the front panel FM/AM button.
The next time you switch on, all the system
settings should be reset.
40
En
Remedy
• Connect the AM antenna (refer to the Setup Guide) and adjust the direction
and position for best reception. You may also connect an additional internal
or external AM antenna (refer to Connecting auxiliary components on
page 26).
• Fully extend the FM wire antenna, position for best reception, and secure to
a wall. You may also connect an outdoor FM antenna (see Connecting external
antennas on page 27).
• Turn off other equipment that may be causing the noise or move it further
away.
• Australian model only – The tuning interval is incorrect for your country or
region. Try switching the tuning interval (frequency step) (see Frequency step
setting on page 37).
• The radio signal is weak. Auto tuning will only detect radio stations with a
good signal. For more sensitive tuning, connect an outdoor antenna.
Description
• An operation is prohibited because the Recording Mode is on (page 27).
• The sound demo is on. See General in Troubleshooting on page 38.
• An operation is prohibited because headphones are connected, or TEST
TONE is pressed during disc playback.
• An operation is prohibited because the DVD/CD function isn't selected.
• The tray lock is on. Contact your Pioneer authorized dealer for instructions.
• An operation is prohibited because the sound is muted (press MUTE).
• Contact your Pioneer authorized service center or your dealer for servicing.
• Appears when a menu is automatically exited after a set period of inactivity.

Using the language code list

Some of the language options (see Language
settings on page 22) allow you to set your
preferred language from any of the 136
languages listed in the Language code list on
page 41.
1
Select 'Other Language'.
2
Use
(cursor left/right) to select
either a code letter or a code number.
3
Use
(cursor up/down) to select a
code letter or a code number.
See the Language code list (next page) for a
complete list of languages and codes.