Pioneer PD-F1005 Service Manual - Page 39

Browse online or download pdf Service Manual for CD Player Pioneer PD-F1005. Pioneer PD-F1005 46 pages. File-type cd player

Print Page

PD-F905

1. SAFETY INFORMATION

This service manual

is intended for qualified service technicians;

it is not meant for the casual

do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been

trained to properly and safely repair complex products such as those covered by this manual.

Improperly performed repairs can adversely affect the safety and reliability of the product and may

void the warranty. If you are not qualified to perform the repair of this product properly and safely, you

should not risk trying to do so and refer the repair to a qualified service technician.

WARNING

Lead in solder used in this product is listed by the California Health and Welfare agency as a known reproductive toxicant which

may cause birth defects or other reproductive harm (California Health & Safety Code, Section 25249.5).

When servicing or handling circuit boards and other components which contain lead in solder, avoid unprotected skin contact with

the solder. Also, when soldering do not inhale any smoke or fumes produced.

(FOR USA MODEL ONLY)

1. SAFETY PRECAUTIONS

ANY MEASUREMENTS

NOT WITHIN THE

The following check should be performed for the

LIMITS OUTLINED ABOVE

ARE INDICATIVE

continued

protection

of the customer

and service

A POTENTIAL

SHOCK

HAZARD

AND

technician.

LEAKAGE CURRENT CHECK

MUST BE CORRECTED BEFORE RETURN-

Measure leakage current to a known earth ground

ING THE APPLIANCE

TO THE CUSTOMER.

(water pipe, conduit,

etc.) by connecting

a leakage

current

tester

such

as Simpson

Model

229-2

2. PRODUCT

SAFETY

NOTICE

equivalent between the earth ground and all exposed

Many electrical and mechanical parts in the appliance

metal parts of the appliance (input/output terminals,

have special safety related characteristics. These are

screwheads,

metal overlays, control shaft, etc.). Plug

often not evident

from visual

inspection

nor the

the AC line cord of the appliance directly into a 120V

protection afforded by them necessarily can be obtained

AC 60 Hz outlet and turn the AC power switch on. Any

by using replacement components

rated for voltage,

current measured must not exceed 0.5 mA.

wattage,

etc. Replacement

parts which

have these

special safety characteristics are identified in this

Service Manual.

Electrical

components

having

such

features

are

identified by marking with

1: onthe schematics and

Reading should

on the parts list in this Service Manual.

not De above

The use of a substitute replacement component which

0.5mA

dose not have the same

safety characteristics as the

PIONEER recommended replacement one, shown in the

parts list in this Service Manual, may create shock, fire,

or other hazards.

Product Safety is continuously under review and new

instructions are issued from time to time. For the latest

information,

always consult the current PlONEER

Service Manual. Asubscription to, or

additional copies

of, PIONEER

Service Manual

may be obtained at a

Nominal charge from PIONEER.

Leakage

current

tester

Test all

exposed metal

surfaces

Also test with

plug reversed

{Using AC adapter

plug as required)

AC Leakage Test