Pioneer PD-F1005 Посібник з експлуатації - Сторінка 39
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Програвач компакт-дисків Pioneer PD-F1005. Pioneer PD-F1005 46 сторінок. File-type cd player
Друкувати сторінкуPD-F905
1. SAFETY INFORMATION
This service manual
is intended for qualified service technicians;
it is not meant for the casual
do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been
trained to properly and safely repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may
void the warranty. If you are not qualified to perform the repair of this product properly and safely, you
should not risk trying to do so and refer the repair to a qualified service technician.
WARNING
Lead in solder used in this product is listed by the California Health and Welfare agency as a known reproductive toxicant which
may cause birth defects or other reproductive harm (California Health & Safety Code, Section 25249.5).
When servicing or handling circuit boards and other components which contain lead in solder, avoid unprotected skin contact with
the solder. Also, when soldering do not inhale any smoke or fumes produced.
(FOR USA MODEL ONLY)
1. SAFETY PRECAUTIONS
ANY MEASUREMENTS
NOT WITHIN THE
The following check should be performed for the
LIMITS OUTLINED ABOVE
ARE INDICATIVE
continued
protection
of the customer
and service
OF
A POTENTIAL
SHOCK
HAZARD
AND
technician.
LEAKAGE CURRENT CHECK
MUST BE CORRECTED BEFORE RETURN-
Measure leakage current to a known earth ground
ING THE APPLIANCE
TO THE CUSTOMER.
(water pipe, conduit,
etc.) by connecting
a leakage
current
tester
such
as Simpson
Model
229-2
or
2. PRODUCT
SAFETY
NOTICE
equivalent between the earth ground and all exposed
Many electrical and mechanical parts in the appliance
metal parts of the appliance (input/output terminals,
have special safety related characteristics. These are
screwheads,
metal overlays, control shaft, etc.). Plug
often not evident
from visual
inspection
nor the
the AC line cord of the appliance directly into a 120V
protection afforded by them necessarily can be obtained
AC 60 Hz outlet and turn the AC power switch on. Any
by using replacement components
rated for voltage,
current measured must not exceed 0.5 mA.
wattage,
etc. Replacement
parts which
have these
special safety characteristics are identified in this
Service Manual.
Electrical
components
having
such
features
are
identified by marking with
a
1: onthe schematics and
Reading should
on the parts list in this Service Manual.
not De above
The use of a substitute replacement component which
0.5mA
Pa
dose not have the same
safety characteristics as the
PIONEER recommended replacement one, shown in the
parts list in this Service Manual, may create shock, fire,
or other hazards.
Product Safety is continuously under review and new
instructions are issued from time to time. For the latest
information,
always consult the current PlONEER
Service Manual. Asubscription to, or
additional copies
of, PIONEER
Service Manual
may be obtained at a
Nominal charge from PIONEER.
Leakage
current
tester
Test all
exposed metal
surfaces
Also test with
plug reversed
{Using AC adapter
plug as required)
AC Leakage Test