Aeotec ZWA003-S Operating Manual - Page 4

Browse online or download pdf Operating Manual for Switch Aeotec ZWA003-S. Aeotec ZWA003-S 9 pages.

Print Page

network.

1. Insert the LIR2450 battery.

2. Place the device within the direct range of your Z-Wave controller.

3. Set the main controller's adding mode (see the controller's manual).

4. Double click the button quickly, the LED indicator should blink fast.

5. Wait for the adding process to end.

6. Successful adding will be confirmed by the Z-Wave controller's message.

TIP:

If you want your NanoMote Quad to be a security device that use

secure/encrypted message to communicate in a Z-Wave network, then a security

enabled Z-Wave controller is

Ⅳ. Z-WAVE NETWORK EXCLUSION

To remove the NanoMote Quad from the Z-Wave network:

1. Insert the LIR2450 battery.

2. Place the device within the direct range of your Z-Wave controller.

3. Set the main controller remove mode (see the controller's manual).

4. Double click the button quickly, the LED indicator should blink fast.

5. Wait for the removing process to end.

6. Successful adding will be confirmed by the Z-Wave controller's message.

V. LOW BATTERY ALARM FUNCTION

NanoMote Quad will send battery report to the lifeline group when button is triggered during

the sleep mode. If the battery level of the NanoMote Quad is less than 20%, the NanoMote

Quad will send a low battery alarm to the main controller.

VI. WAKE UP

Pressing and holding button for 5 seconds and then release so the NanoMote Quad will wake up

itself and send wake-up notification out to Z-Wave Controller. After that, it can be operated to

update parameters, OTA, and detect battery level etc.

VII. CHILD LOCK FUNCTION

Child Lock function. If enable the Child Lock function, the LED indicator will not be on when press

needed.