Aeotec ZWA003-S Operating Manual - Page 5

Browse online or download pdf Operating Manual for Switch Aeotec ZWA003-S. Aeotec ZWA003-S 9 pages.

Print Page

down the button. To switch on/off the Child Lock function, please press and hold the button for

10 seconds, the LED indicator will be solid on in red. Then release the button, the LED indicator

will be continuously stay in red for 2 seconds. During this 2 seconds, please click the button once,

the LED light will be blink fast in red for 2 seconds.

VIII. TESTING Z-WAVE NETWORK RANGE

Press and hold the button for 15 seconds, the LED light will be solid on in purple. Then release

the button, the LED light will be stay in purple for 2 seconds, during this 2 seconds, please click

the button once, it will start to test the Z-Wave network range and LED light will blink fast in

purple. After finish the test, if the LED light is in green, it refers to strong signal; if in blue, it refers

to medium signal, and if in red, it refers to weak signal or no signal.

TIP:

This function works only when NanoMote Quad has been included into a

Z-Wave network.

IX. RESET NANOMOTE QUAD

Reset procedure clears the NanoMote Quad's memory, including Z-Wave network information.

To reset NanoMote Quad:

Press and hold the button for 20 seconds, the LED light will be solid on in red. Then release the

button, the LED light will be stay in red for 2 seconds, during this 2 seconds, please click the

button once, it will start to restore factory default. At the same time, the LED light will be solid on

in colorful for 15 seconds. Then Sending Device Reset locally notification to the controller.

NOTE:

Use this procedure only in the event that the network primary controller is

missing or otherwise inoperable.

X. BATTERY CHARGING

NanoMote Quad has an internal rechargeable battery that will run for three months under the

normal use condition. The charger's output should be a micro USB terminal with the specification