Acom 1000 Installation - Page 2

Browse online or download pdf Installation for Amplifier Acom 1000. Acom 1000 3 pages.

Print Page

2. Discharging HV capacitors.

Using a piece of wire connected to the rear-panel grounding stud, DISCHARGE

residual charges from THE HV CAPACITORS (if any) by short-circuiting the three

points shown in the picutre below.

3. Installing the top cover.

a) Using a Philips-1 screwdriver, unscrew 15 countersunk-head screws and

remove the RF screen from RF deck. Put the cover on the chassis while

holding its rear edge lifted slightly (to 2-3cm) above the chassis.

Align its horizontal and two vertical front edges to the respective

chutes in the front panel. Then push gently the cover forwards, in order

to insert its front edges into the chutes. Take care especially to the

bottom corners.

b) Screw in loosely all 9 pcs of "eco-fix" flange-button head screws. Use a

Philips-2 screwdriver.