Whirlpool AWM 9100 Programme Chart - Page 3

Browse online or download pdf Programme Chart for Washer Whirlpool AWM 9100. Whirlpool AWM 9100 3 pages.

Print Page

If you wish to connect only the cold

fill follow the below

instruction (Fig. 1):

1. You need the enclosed Y-piece connector.

2. Fix the Y-piece connector to the cold fill

tap.

3. Connect the two inlet valves present on

the rear part of the machine to the Y-piece

connector using the relative provider

hoses.

Make sure:

All connections are tightly fixed.

COLD / HOT FILL INSTRUCTION

Please observe that both inlet valves (white and red) of the

washing machine have to be connected to the water supply.

There are two alternative ways of doing this:

Cold fill

Y-piece

White inlet valve

Red inlet valve

Fig. 1

Do not allow children to operate, crawl on, near or inside your

washer.

Note that during wash cycles, the surface temperature of the

porthole door may increase.

Close supervision of children is necessary when the appliance is

used near children.

Hot fill

Cold fill

White inlet valve

Red inlet valve

Fig. 2

If you wish to connect

hot and cold water supply

(Fig. 2):

1. Fix the red marked inlet hose at the hot

water tap and at the inlet valve with the

red filter on the rear side of machine.

2. Fix the other inlet hose at the cold water

tap and at the inlet valve with the white

filter on the rear side of the machine.

Make sure:

a) The connections are tightly fixed

b) Do not invert their position

(for example: cold fill into hot inlet valve

and viceversa).

Whirlpool is a registered trademark of Whirlpool USA

5019 301 15169