Whirlpool AWM 9100 Program Tablosu - Sayfa 3
Yıkayıcı Whirlpool AWM 9100 için çevrimiçi göz atın veya pdf Program Tablosu indirin. Whirlpool AWM 9100 3 sayfaları.
Sayfayı YazdırIf you wish to connect only the cold
fill follow the below
instruction (Fig. 1):
1. You need the enclosed Y-piece connector.
2. Fix the Y-piece connector to the cold fill
tap.
3. Connect the two inlet valves present on
the rear part of the machine to the Y-piece
connector using the relative provider
hoses.
Make sure:
All connections are tightly fixed.
COLD / HOT FILL INSTRUCTION
Please observe that both inlet valves (white and red) of the
washing machine have to be connected to the water supply.
There are two alternative ways of doing this:
Cold fill
Y-piece
White inlet valve
Red inlet valve
Fig. 1
Do not allow children to operate, crawl on, near or inside your
washer.
Note that during wash cycles, the surface temperature of the
porthole door may increase.
Close supervision of children is necessary when the appliance is
used near children.
Hot fill
Cold fill
White inlet valve
Red inlet valve
Fig. 2
If you wish to connect
hot and cold water supply
(Fig. 2):
1. Fix the red marked inlet hose at the hot
water tap and at the inlet valve with the
red filter on the rear side of machine.
2. Fix the other inlet hose at the cold water
tap and at the inlet valve with the white
filter on the rear side of the machine.
Make sure:
a) The connections are tightly fixed
b) Do not invert their position
(for example: cold fill into hot inlet valve
and viceversa).
Whirlpool is a registered trademark of Whirlpool USA
5019 301 15169