Ariston ASL 65 VXS NA - 35140 Care, Use And Installation Booklet - Page 10

Browse online or download pdf Care, Use And Installation Booklet for Dryer Ariston ASL 65 VXS NA - 35140. Ariston ASL 65 VXS NA - 35140 40 pages. Tumble dryer

Print Page

Troubleshooting

Before you call our Customer Care Department, go through the following troubleshooting suggestions:
EN
Problem:
The dryer won't start.
Drying cycle will not begin.
Its taking a long time to dry.
Program finishes and clothes
are damper than expected.
The display shows a fault
code F followed by one or two
numbers.
If you still have a problem call our Customer Care Department on: 1 888 426 0825

Spare Parts

This dryer is a complex machine. Repairing it yourself or having a non-authorized person try to repair it could
cause harm to one or more persons and to the machine, and could invalidate the spare parts warranty.
Call an authorized service center if you experience problems while using the machine.
Contact number: 1 888 426 0825
www.aristonappliances.us
10
Possible causes / Solution:
The plug is not plugged into the socket, or not making contact.
There has been a power outage.
The fuse has blown. Try to plug another appliance into the socket.
You are using an extension cord? Try to plug the dryer's power cord
directly into the socket.
The door is not closed securely?
The PROGRAMS knob has not been set properly (see Start and Programs).
The START button has not been pressed (see Start and Programs).
You have set a delay time (see Start and Programs).
The filter has not been cleaned (see Maintenance).
The correct program has not been selected for the type of fabric you are
drying (see Start and Programs).
The exhaust duct is obstructed (see Installation).
The air intake vent is obstructed (see Installation).
The permanent ventilation flap on the storm cover is obstructed (see

Installation).

The items were too wet (see Laundry).
The dryer was overloaded (see Laundry).
! For safety the dryer has a maximum program time of 3 hours. If an
automatic program has not sensed the required final moisture in this time
the dryer will complete the program and stop. Check the above points and
run the program again, if the results are still damp, contact our Customer
Care Department.
Note down the code and contact the our Customer Care Department.