Ariston ASL 75 CXS NA Care, Use And Installation Booklet - Page 4
Browse online or download pdf Care, Use And Installation Booklet for Dryer Ariston ASL 75 CXS NA. Ariston ASL 75 CXS NA 40 pages. Condensation dryer
Also for Ariston ASL 75 CXS NA: Datasheet (1 pages), Brochure & Specs (8 pages), Use And Installation Manual (40 pages), Repair Manual (18 pages)
Print Page
Start and Programs
Choosing a program
EN
1. Plug the dryer into the electrical socket.
2. Sort your laundry according to fabric type (see
Laundry).
3. Open the door and make sure the filter is clean
(see Maintenance).
4. Load the machine and make sure items are not
in the way of the door seal. Close the door.
5. If the On/Off light is not lit: Press the ON/OFF
button.
6. Choose a program by checking the Programs Guide
(see Programs) as well as the indications for each
type of fabric (see Laundry).
- Select a program by rotating the PROGRAMS
knob.
7. Set a delay time and other options if necessary.
8. If you wish to select the buzzer, to sound at the
end of the program, press the ALARM Option button.
Easy Iron Program
Easy Iron is a short 10 minute programme (8 minutes of heat followed by a 2 minute Air Fluff period) which fluffs
the fibers of clothing that have been left in the same position/location for an extended period of time. The cycle
relaxes the fibers and makes them easier to iron and fold.
! Easy Iron is not a drying program and should not be used for wet articles of clothing.
For best results:
1. Do not load more than the maximum capacity.
These numbers refer to the dry weight:
Fabric
Regular Cotton and Regular Cotton mix
Permanent Press
Denim
2. Unload the dryer immediately after the end of the program, hang, fold or iron the articles and put them away.
Should this not be possible, repeat the program.
The Easy Iron effect varies from one fabric to the next. It works very well on traditional fabrics like Regular
Cottons or Regular Cotton mix, and less well on acrylic fibers.
www.aristonappliances.us
4
9. Press the START button to begin.
During the drying program, you can check on
your laundry and take out the items that are dry
while others continue drying. When you close
the door again, press the START button in order
to resume drying.
10. During the last few minutes of Drying Programs,
before the program is completed, the final AIR
FLUFF phase is entered (fabrics are cooled), this
phase should always be allowed to complete.
11. When the program is complete. The buzzer will
sound if the Alarm option was selected.
Open the door, take your laundry out, clean the filter
and replace it (see Maintenance).
If the Post Creasecare option has been selected
and you do not take the clothes out immediately,
the clothes will tumble occasionally for 10 hours or
until you open the door.
12. Unplug the dryer.
Maximum load
5.5 lb / 2.5 kg
4 lb / 2 kg
4 lb / 2 kg