Whirlpool 30 " Eye-Level Gas Range Installation Instructions Manual - Page 5

Browse online or download pdf Installation Instructions Manual for Ventilation Hood Whirlpool 30 " Eye-Level Gas Range. Whirlpool 30 " Eye-Level Gas Range 10 pages. Freestanding gas range with self-cleaning oven
Also for Whirlpool 30 " Eye-Level Gas Range: Installation Instructions And Use And Care Manual (32 pages), Installation Instructions Manual (11 pages), Installation Instructions And Use & Care Manual (28 pages), Installation Instructions Manual (11 pages), Installation Instructions (5 pages), Installation Instructions Manual (28 pages), Installation Instructions Manual (48 pages), Installation Instructions Manual (32 pages), Installation Instructions Manual (12 pages), Installation Instructions (5 pages), Installation Instructions Manual (7 pages), Installation Manual (7 pages), Installation Instructions Manual (7 pages), Installation Instructions (5 pages), Installation Instructions Manual (7 pages)

Print Page
Whirlpool 30
Operating position
Before moving range across floor, check that
range is still on cardboard shipping base to
protect floor covering.
front leveling leg
6
n
Making sure the
anti-tip bracket is
installed:
l
Look for the
anti-tip
anti-tip bracket
bracket
securely attached to
8
'W Place rack in oven. Place level on rack,
floor.
first side to side; then front to back.
l
Slide range back so rear range foot is under
If range is not level, pull range forward until
anti-tip bracket.
rear leveling leg is removed from the anti-tip
5
bracket. Use 3/8" drive ratchet and channel lock
n
Remove cardboard shipping base from
7
pliers to adjust leveling legs up or down until
under range. Open broiler drawer. Use a 3/8"
range is level. Push range back into position.
drive ratchet to lower rear leveling legs one-
n
If installing the range in a mobile
Check that rear leveling leg is engaged in anti-
home, you MUST secure the range to the floor.
tip bracket.
half turn. Use channel lock pliers to lower front
leveling legs one-half turn.
Any method of securing the range is adequate as
long as it conforms to the "Manufactured
Home
Note: Oven must be level for satisfactory
Construction and Safety Standard," Page 2.
baking conditions.
Gas and electrical connections
All connections must be wrench-tightened.
Typical rigid pipe connection
n
Use a brush and liquid detergent
to test all gas connections. Bubbles around
connections will indicate a leak. If a leak
appears, shut off gas valve controls and
tighten connections. Then check connections
again. Never test for gas leaks with a match or
other flame. Clean all detergent from range.
Replace broiler drawer/close broiler drawer.
n
Use 15/16' combination wrench and
channel lock pliers to tighten fittings and flexible
connector, if used. Be certain connectors are not
n
Place burner grates over surface
burner.
n
Plug power supply cord into
grounded electrical outlet.
Typical flexible connection
"on" position
-
connector
w Check that range regulator shutoff
valve is in the "on" position. Open the manual
shutoff valve in the gas supply line.
A l/2" male pipe thread is needed for connection to
pressure regulator female pipe threads.
9
n
Assemble the adapter fittings provided
with the flexible connector to the gas supply
pipe. Use pipe-joint compound suitable for use
with L.P. gas to seal all pipe thread
connections to the pressure regulator.
Page 5