Whirlpool 30 " Eye-Level Gas Range Інструкція з монтажу Посібник з монтажу - Сторінка 5

Друкувати сторінку

Operating position

Before moving range across floor, check that

range is still on cardboard shipping base to

protect floor covering.

front leveling leg

Making sure the

anti-tip bracket is

installed:

Look for the

anti-tip

anti-tip bracket

bracket

securely attached to

'W Place rack in oven. Place level on rack,

floor.

first side to side; then front to back.

Slide range back so rear range foot is under

If range is not level, pull range forward until

anti-tip bracket.

rear leveling leg is removed from the anti-tip

bracket. Use 3/8" drive ratchet and channel lock

Remove cardboard shipping base from

pliers to adjust leveling legs up or down until

under range. Open broiler drawer. Use a 3/8"

range is level. Push range back into position.

drive ratchet to lower rear leveling legs one-

If installing the range in a mobile

Check that rear leveling leg is engaged in anti-

home, you MUST secure the range to the floor.

tip bracket.

half turn. Use channel lock pliers to lower front

leveling legs one-half turn.

Any method of securing the range is adequate as

long as it conforms to the "Manufactured

Home

Note: Oven must be level for satisfactory

Construction and Safety Standard," Page 2.

baking conditions.

Gas and electrical connections

All connections must be wrench-tightened.

Typical rigid pipe connection

Use a brush and liquid detergent

to test all gas connections. Bubbles around

connections will indicate a leak. If a leak

appears, shut off gas valve controls and

tighten connections. Then check connections

again. Never test for gas leaks with a match or

other flame. Clean all detergent from range.

Replace broiler drawer/close broiler drawer.

Use 15/16' combination wrench and

channel lock pliers to tighten fittings and flexible

connector, if used. Be certain connectors are not

Place burner grates over surface

burner.

Plug power supply cord into

grounded electrical outlet.

Typical flexible connection

"on" position

connector

w Check that range regulator shutoff

valve is in the "on" position. Open the manual

shutoff valve in the gas supply line.

A l/2" male pipe thread is needed for connection to

pressure regulator female pipe threads.

Assemble the adapter fittings provided

with the flexible connector to the gas supply

pipe. Use pipe-joint compound suitable for use

with L.P. gas to seal all pipe thread

connections to the pressure regulator.

Page 5