Whirlpool GZ5730XR Series Installation Instructions And Use And Care Manual - Page 7
Browse online or download pdf Installation Instructions And Use And Care Manual for Ventilation Hood Whirlpool GZ5730XR Series. Whirlpool GZ5730XR Series 24 pages. 30" (76.2 cm) and 36" (91.4 cm) convertible range hood
Also for Whirlpool GZ5730XR Series: Dimensions (1 pages), Installation Instructions And Use And Care Manual (24 pages), Installation Instructions And Use & Care Manual (24 pages), Installation Instructions And Use & Care Manual (24 pages)
Print Page
2. Remove tape holding standard filters in place. Remove both
filters. Insert flat blade screwdriver into slots in filters. Push
each filter toward back of hood, lift out and set aside.
A
A. Filter slots
B. Flat blade screwdriver
3. Remove damper/vent connector from inside the hood. Set
connector, mounting screws and parts bag aside.
A
A. Damper/vent connector
4. Remove wiring cover from inside the hood. Set cover and
mounting screw aside.
A
A. Wiring cover
5. Depending on your installation, remove either top or back
wiring knockout and install a ¹⁄₂" UL- or CSA-listed strain
relief.
A
A. Strain relief
For non-vented installations
Go to "Make Electrical Connection" section.
For vented installations
1. Remove the five screws holding the light panel in place and
set them aside.
2. Disconnect the light assembly wiring connector.
3. Remove the light panel and set aside.
B
4. Remove the air chute held in place with one screw.
5. Remove baffle from air chute.
6. Rotate baffle and reinsert it back into the air chute so that the
7. Replace air chute.
8. Connect light assembly wiring connector and replace light
Make sure not to disconnect any wires.
A. Light panel
A. Air chute
A
A. Baffle
baffle tabs fit all the way into the slots in the air baffle.This will
close off the air flow through the non-vented slots on top of
the hood.
A
A. Tab slots
B. Tabs
panel.
NOTE: Make sure not to trap wires between the support fin
and light panel.
A
A
B
7