Whirlpool GZ5730XR Series Инструкция по установке и руководство по эксплуатации и уходу - Страница 7

Просмотреть онлайн или скачать pdf Инструкция по установке и руководство по эксплуатации и уходу для Вентиляционная вытяжка Whirlpool GZ5730XR Series. Whirlpool GZ5730XR Series 24 страницы. 30" (76.2 cm) and 36" (91.4 cm) convertible range hood
Также для Whirlpool GZ5730XR Series: Размеры (1 страниц), Инструкция по установке и руководство по эксплуатации и уходу (24 страниц), Инструкции по установке и руководство по эксплуатации и уходу (24 страниц), Инструкции по установке и руководство по эксплуатации и уходу (24 страниц)

2. Remove tape holding standard filters in place. Remove both

filters. Insert flat blade screwdriver into slots in filters. Push

each filter toward back of hood, lift out and set aside.

A. Filter slots

B. Flat blade screwdriver

3. Remove damper/vent connector from inside the hood. Set

connector, mounting screws and parts bag aside.

A. Damper/vent connector

4. Remove wiring cover from inside the hood. Set cover and

mounting screw aside.

A. Wiring cover

5. Depending on your installation, remove either top or back

wiring knockout and install a ¹⁄₂" UL- or CSA-listed strain

relief.

A. Strain relief

For non-vented installations

Go to "Make Electrical Connection" section.

For vented installations

1. Remove the five screws holding the light panel in place and

set them aside.

2. Disconnect the light assembly wiring connector.

3. Remove the light panel and set aside.

4. Remove the air chute held in place with one screw.

5. Remove baffle from air chute.

6. Rotate baffle and reinsert it back into the air chute so that the

7. Replace air chute.

8. Connect light assembly wiring connector and replace light

Make sure not to disconnect any wires.

A. Light panel

A. Air chute

A. Baffle

baffle tabs fit all the way into the slots in the air baffle.This will

close off the air flow through the non-vented slots on top of

the hood.

A. Tab slots

B. Tabs

panel.

NOTE: Make sure not to trap wires between the support fin

and light panel.