Whirlpool UXD8630DYS Installation Use & Care Instructions - Page 11
Browse online or download pdf Installation Use & Care Instructions for Ventilation Hood Whirlpool UXD8630DYS. Whirlpool UXD8630DYS 40 pages. 30 76.2 cm and 36 91.4 cm retractable pop-up downdraft vent system
Also for Whirlpool UXD8630DYS: Installation Instructions And Use & Care Manual (36 pages), Installation Instructions And Use & Care Manual (44 pages)
Print Page
5. Attach the support legs to the side of the vent box with four
4 x 8 mm screws in each support leg. Adjust to dimension "Y"
from the bottom of the vent box to the bottom of the support
legs. Tighten screws.
A
A. Motor box
B. Support leg
C. 4 x 8 mm screws (4)
Determine Which Vent Direction Is Best for
Your Installation
When installed in a cabinet, vent system can exhaust through
the bottom, left, or right of the cabinet.
IMPORTANT: When using the 6" (15.2 cm) vent transition
(supplied) for 6" round venting, only left or right venting is
recommended.
Bottom Venting:
NOTE: If installing the vent damper in the down position, a wall
or roof cap with a damper at the exit end of the vent system
is required.
Downdraft vent is shipped with blower in down-venting
■
position, so no modification is required.
If rear mounting of the blower motor is not required, go
■
to the "Complete Installation" section.
To mount the blower motor to the rear side of the vent box,
■
go to the "Rear Mounting — Blower Motor" section.
Left or Right Venting:
1. Using two or more people, place the downdraft vent system
2. Remove the four screws from the cover plate mounted to the
C
Dim. "Y"
B
3. Slide the cover plate up and slip it over the keyhole slot
4. Remove four screws from the bottom of the motor box that
5. Remove three screws and the vent cover plate from the left
6. Rotate the blower motor assembly 90° to the left or right side
7. Install the vent cover plate over the rectangular opening in the
8. Reinstall the cover plate to the face of the motor box and
9. For mounting the blower motor to the back of the vent
on its back.
face of the motor box and set them aside.
A
B
C
D
A. Cover plate
B. Cover plate screws (4)
C. Cover plate keyhole slot
shoulder screws (4)
shoulder screws. Set the cover aside.
hold the motor assembly to the motor box.
NOTE: Disconnect the electrical wiring connection from
motor if needed.
or right side of the motor box for the venting direction to be
used.
to the chosen venting direction and secure to the blower box
with motor mounting screws previously removed. Do not
twist or bind the wires.
bottom of the motor box and secure with vent cover screws.
NOTE: Reinstall the electrical wiring connection to motor if
removed.
secure with four cover plate screws previously removed.
box, go to the "Rear Mounting - Blower Motor" section.
Otherwise, go to the "Complete Installation" section.
G
F
E
D. Motor mounting screws (4)
E. Vent cover plate
F. Motor box
G. Vent cover screws (3)
11