Whirlpool UXT4030AY Installation Instructions And Use & Care Manual - Page 8
Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood Whirlpool UXT4030AY. Whirlpool UXT4030AY 24 pages. 30" (76.2 cm) and 36" (91.4 cm) range hood
Also for Whirlpool UXT4030AY: Installation Instructions And Use And Care Manual (32 pages), Installation Instructions And Use & Care Manual (36 pages)
Print Page
1. Install the 75W (max.) Incandescent light bulb. See
"Replacing the Incandescent Light Bulb" in the "Range Hood
Care" section.
2. Replace grease filter if removed. See the "Range Hood Care"
section.
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The hood controls are located on the top of the range hood.
A
A. Incandescent light housing and cover
B. Charcoal filter retainer
C. Grease filter
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filter
before operating hood.
Exterior Surfaces:
IMPORTANT: Do not use soap-filled scouring pads, abrasive
cleaners, Cooktop Polishing Creme, steel wool, gritty washcloths
or paper towels.
To avoid damage to the stainless steel, do not use cleaners that
contain chlorine.
Cleaning Method:
Rub in direction of grain to avoid scratching or damaging the
surface.
For stainless steel models, Stainless Steel Cleaner and Polish
Part Number 31462A (not included): See "Assistance or
Service" section to order.
Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
Glass cleaner to remove fingerprints.
8
Complete Installation
RANGE HOOD USE
B
C
RANGE HOOD CARE
3. Check the operation of the range hood fan and light. See
"Range Hood Use" section.
If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
Disconnect power and check wiring connections.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
Range Hood Controls
On
Operating the light
Push the light switch to the right to turn the light Off. Push the
light switch to the left to the turn the light On.
Operating the fan
Push the fan switch to the left for Low speed. Push the fan
switch to the right for High speed. Push the fan switch to the
middle for Off.
Cleaning
Charcoal Filter
The charcoal filter is not washable. It should last up to 6 months
with normal use.
Replace the old charcoal filter with a new charcoal filter. For
information on ordering, see the "Accessories" section.
To replace filter:
1. Remove screw from the filter retainer.
2. Turn the filter retainer to release filter.
3. Reinstall the filter by placing the back edge in the channel at
rear of hood. Push filter into place, turn the filter retainer to
secure filter to range hood.
4. Replace screw in the filter retainer.
Off
Off
Low
B
A
A. On/Off light switch
B. Fan speed switch
A
A. Filter retainer
High