Whirlpool WVW73UC0LS Installation Instructions And Use & Care Manual - Page 11
Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood Whirlpool WVW73UC0LS. Whirlpool WVW73UC0LS 28 pages. Canopy wall mount range hood
Print Page
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease
filters before operating hood.
Exterior Surfaces
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
Liquid detergent soap and water, or all-purpose cleanser
■
Wipe with damp soft cloth or nonabrasive sponge,
■
and then rinse with clean water and wipe dry.
Metal Grease Filter
1. Remove the filter by pulling the spring release handle
and then pulling down the filter.
A
A. Spring release handle
2. Wash metal filter as needed in dishwasher or hot
detergent solution.
3. Reinstall the filter by making sure the spring release handles
are toward the front. Insert aluminum filter into upper track.
4. Push in spring release handle.
5. Push up on metal filter and release handle to latch into place.
6. Repeat steps 1-5 for the other filter.
Non-Vented (recirculating) Installation Filters
The charcoal filter is not washable. It should last up to 6 months
with normal use. Replace with Charcoal Filter Kit. See the
"Assistance or Service" section for information on ordering.
To replace charcoal filter:
1. Remove metal grease filter from range hood. See "Metal
Grease Filter" in this section.
2. Bend spring clips away from metal grease filter.
RANGE HOOD CARE
Cleaning
3. Place charcoal filter into top side of metal filter.
4. Bend spring clips back into place to secure the
5. Replace metal grease filter. See "Metal Grease Filter"
Turn off the range hood and allow the LED lamp to cool. To avoid
damage or decreasing the life of the new bulb, do not touch bulb
with bare fingers. Replace bulb, using tissue or wearing cotton
gloves to handle bulb. Replace it with an appropriate Energy
Star Compliant Lamp, 120 V~, 7.5 W maximum, LED bulb with a
GU10 base.
If new lamps do not operate, make sure the bulbs are inserted
correctly before calling service.
1. Disconnect power.
2. Push up on the lens and turn it counterclockwise.
3. Remove the bulb and replace it with a 120 V~, 7.5 W
4. Repeat steps 2-3 for the other bulb if needed.
5. Reconnect power.
charcoal filter to the metal filter.
in this section.
Replacing a LED Lamp
maximum LED bulb with a GU10 base. Turn it clockwise to
lock it into place.
11