Whirlpool YUMV4084 Installation Instructions Manual - Page 9
Browse online or download pdf Installation Instructions Manual for Ventilation Hood Whirlpool YUMV4084. Whirlpool YUMV4084 24 pages. Microwave hood combination
Also for Whirlpool YUMV4084: Use & Care Manual (15 pages), Use & Care Manual (28 pages)
Print Page
Install Visor
1. Open visor, and slide its mounting tray – with the mounting
tray edges facing down – into the slot between the microwave
oven bottom and the bottom plate, as shown.
A
A. Visor
B. Visor mounting tray
C. Bottom plate
2. Secure visor by installing two 17 mm shoulder screws through
the bottom plate into the visor mounting tray.
A
A. Visor
B. 17 mm shoulder
C. Bottom plate
Install Charcoal Filter Kit
(for recirculation venting only)
The charcoal filter kit should be used. See "Assistance" section
for information on ordering.
To Install Charcoal Filter:
1. Cover the inside of the grease filter with the charcoal filter.
A
A. Charcoal filter
B. Grease filter
B
C
B
C
screws
B
2. Insert wire rods to hold charcoal filter in place.
A
A. Charcoal filter
B. Grease filter
C. Wire rods
3. Install grease filter. See "Install Grease Filter" section.
Install Grease Filter
1. Place bracket end of the grease filter into one side of the
bottom plate opening, push toward the bracket end, and
swing up the tabbed end of the grease filter.
C
A. Grease filter
B. Tabs
C. Bracket
2. Push the tabbed end of the grease filter up until the tabs are
above the opening, then release the tension.
B
C
A
B
9