Whirlpool YUMV4084 Інструкція з монтажу Посібник з монтажу - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Вентиляційна витяжка Whirlpool YUMV4084. Whirlpool YUMV4084 24 сторінки. Microwave hood combination
Також для Whirlpool YUMV4084: Посібник з використання та догляду (15 сторінок), Посібник з використання та догляду (28 сторінок)

Install Visor

1. Open visor, and slide its mounting tray – with the mounting

tray edges facing down – into the slot between the microwave

oven bottom and the bottom plate, as shown.

A. Visor

B. Visor mounting tray

C. Bottom plate

2. Secure visor by installing two 17 mm shoulder screws through

the bottom plate into the visor mounting tray.

A. Visor

B. 17 mm shoulder

C. Bottom plate

Install Charcoal Filter Kit

(for recirculation venting only)

The charcoal filter kit should be used. See "Assistance" section

for information on ordering.

To Install Charcoal Filter:

1. Cover the inside of the grease filter with the charcoal filter.

A. Charcoal filter

B. Grease filter

screws

2. Insert wire rods to hold charcoal filter in place.

A. Charcoal filter

B. Grease filter

C. Wire rods

3. Install grease filter. See "Install Grease Filter" section.

1. Place bracket end of the grease filter into one side of the

bottom plate opening, push toward the bracket end, and

swing up the tabbed end of the grease filter.

A. Grease filter

B. Tabs

C. Bracket

2. Push the tabbed end of the grease filter up until the tabs are

above the opening, then release the tension.