ERGODYNE SQUIDS Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for Safety Equipment ERGODYNE SQUIDS. ERGODYNE SQUIDS 2 pages. Tool attachment

Print Page

FIG. 1

WARNINGS: ALL WARNINGS AND INSTRUCTIONS MUST BE READ AND

UNDERSTOOD BEFORE USING THIS PRODUCT. FAILURE TO DO SO MAY RESULT

IN PROPERTY DAMAGE, SERIOUS INJURY, OR DEATH.

Squids® Split Rings are designed to be retrofit tool attachments to create tethering

connection points on tools that don't have adequately sized connection points to begin

with.

Unless otherwise noted the Squids® Split rings are rated for tools weighing no more

than 2lbs // 0.9kg and are intended to be installed into smaller captive connection

points that already exist on the tool.

• Do not use Tool Attachments in temperatures below -40°F / -40°C or above

150°F / 65°C.

• Never exceed the allowable capacity for any tethering system component. Refer

to individual component's label. Your tethering system is only as strong as your

weakest link.

• Tool and lanyards are for tool use only. They are not for human support, nor are

they intended to be part of a human fall protection system.

• For tools weighing more than 5lbs / 2.26kg, do not tether such tools to the human

body, unless specifically authorized per the product instructions.

• Always inspect tool lanyards and all parts of your tethering system prior to, and

after, each use (refer to inspection steps).

• Never modify or alter tool attachments.

• Never modify a tool or primary anchoring location that could result in

manufacturer guideline deviation.

• Do not use this product if it interferes with the tool's safe working condition,

or the anchoring location—including personal fall protection.

• Use extra precaution around moving machinery or parts, electrical hazards,

chemical hazards or other apparent hazards.

• Never attach a tool with a Squids® Tool Attachment to a lanyard that is longer than

the Maximum Lanyard Length indicated on the product label of the attachment.

• Always wear appropriate personal protective equipment when installing or using

tethering systems.

SPLIT RING INSTALLATION

• Weigh the tool to be retrofitted with the split ring and ensure it does not

exceed 2lbs // 0.9kg and make sure the attachment area is clean and dry before

application.

• For easier installation use a split ring pliers or other pliers to help pry the split ring

open.

1. Open one end of the split ring wire. (Fig. 1)

2. Slide the open end through desired location on the tool and twist until the ring is

fully captured on the tool. (Fig. 2)

3. Connect a tool lanyard to complete your tethering system. (Fig. 3)

After use, clean the Split Rings and connected tool or equipment to remove dirt,

corrosives or contaminants. Wipe with a clean cloth and hang to dry away from

excessive heat, steam, or sunlight.

Store in a clean and dry environment, free from fumes or corrosive elements. Proper

care of safety equipment helps to ensure that it will operate effectively and to extend

its service life.

FIG. 2

FIG. 3