Xerox Synergix 8850 Software Manual - Page 12

Browse online or download pdf Software Manual for Software Xerox Synergix 8850. Xerox Synergix 8850 30 pages. Windows nt 4.0 postscript print driver user guide
Also for Xerox Synergix 8850: Setup Manual (20 pages), Release Note (23 pages), Release Note (8 pages), Customer Training Manual (50 pages)

Print Page
Xerox Synergix 8850 Software Manual
XES Synergix 8825/8830/8850/8855 Windows NT 4.0 PostScript Print Driver User Guide
Driver Configuration (Printer Properties Dialog)

Device Settings Parameters

The Device Settings tab of the Printer Properties dialog contains a number of
configurable device settings.
Form to Tray Assignment
Manual Feed Setting - Lets you set the size of the manual feed option
on the printer if the printer is so equipped. It is recommended that you
leave this setting at the default of letter.
Roll Settings - Use these parameters to set up the driver with the sizes
of media rolls installed in the printer. For the 8855 printer there will
typically be four Rolls to set. It is recommended that you leave this
setting at the default of letter.
Font Substitution Table - Displays a list of your system-installed fonts and
the printer-resident fonts set for their replacement if you choose Substitute
with Device Font in the True Type Font parameter of the Advanced Tab of the
Document Properties Dialog as stated in this Guide.
Available PostScript Memory - Specifies the amount of PostScript memory
which is a subset of total printer physical memory. The driver uses this
information when performing printing tasks, such as sending fonts from the
computer to the printer. Unless PostScript printing problems are occurring, it
is best if the default setting of 2048 kilobytes is used. The range for this
setting is 249 to 32767KB.
Figure 3. Typical Device Settings Tab
8