Xerox Synergix 8850 Software Manual - Page 13

Browse online or download pdf Software Manual for Software Xerox Synergix 8850. Xerox Synergix 8850 30 pages. Windows nt 4.0 postscript print driver user guide
Also for Xerox Synergix 8850: Setup Manual (20 pages), Release Note (23 pages), Release Note (8 pages), Customer Training Manual (50 pages)

Print Page

Parameters of the Device Settings Tab (continued)

Output Protocol – Specifies the output format. It is recommended that you

leave this setting at the default of ASCII.

Add Euro Currency Symbol to PostScript Fonts – This setting adds the

euro currency symbol to most PostScript fonts.

Job Timeout - Leave this setting at the default of 0 seconds.

Wait Timeout Leave this setting at the default of 300 seconds.

Minimum Font Size to Download as Outline - Specifies the minimum font

size (in pixels) for which the PostScript driver will download TrueType fonts

as scaleable outline (Type 1) fonts. A font smaller than the minimum setting

will be downloaded as a bitmap (Type 3/Type 32) font. This option essentially

lets you fine tune the Automatic setting for the TrueType Font Download

option on the Advanced tab in the Document Properties dialog box (available

from "File," "Print," "Properties" in your desktop application).

Maximum Font Size to Download as Bitmap - Specifies the maximum font

size (in pixels) for which the PostScript driver will download TrueType fonts

as bitmap (Type 3/Type 32) fonts. A font larger than the maximum setting

will be downloaded as a scaleable outline (Type 1) font. This option lets you

fine tune the Automatic setting or override the bitmap (Type 3/Type 32)

setting for the TrueType Font Download option on the Advanced tab in the

Document Properties dialog box (available from "File," "Print," "Properties" in

your desktop application).

AccXES Settings

About AccXES Plug-in - Select this option and click the "About AccXES

Plug In" button to display a screen informing you of the version number of

the XES features created to work with this PostScript driver.

Select Finisher - Select this option, then click the "Select Finisher"

button to open and import a Finisher (.fin) file into the driver. This file

informs the driver of available Finishing Device options to display under

the Finisher group of the Job Tab of the Document Properties Dialog.

Note: Make sure that the Finisher file that you select matches the

capabilities of the Finisher (folder) that you purchased. If necessary, you

can create your own Finisher file using the XESFin.exe program and

XES Synergix 8825/8830/8850/8855 Windows NT 4.0 PostScript Print Driver User Guide

instructions available on the Internet at www.xes.com. After downloading

the executable file to your workstation, open a command prompt on your

desktop and provide the path to the "xesfin.exe" file on your workstation.

A sample entry might be: C:\Temp>xesfin.exe (assuming the executable

file was downloaded to your Temp directory). Press Enter. At the

command prompt, create a command like the example shown on screen.

With the finishing device attached to your printer's Controller and

powered on, press Enter to create your own finisher file. You can then

use the Select Finisher button as described above to import the finisher

file into this driver.

Display Units - Select this option to enable you to choose "display units"

in inches or millimeters for all applicable, driver-displayed options. The

driver default setting is English (inches).

Firmware Revision - Select the version of AccXES firmware currently

installed in your printer's Controller for the correct display of firmware-

supported driver options.