Alderon Industries 7001 Versa’larm Operation, Maintenance And Installation Manual

Browse online or download pdf Operation, Maintenance And Installation Manual for Security System Alderon Industries 7001 Versa’larm. Alderon Industries 7001 Versa’larm 3 pages. Tank alarm

Print Page

7001 Versa'larm

Tank Alarm

Operation, Maintenance

and Installation Manual

Warning! Turn off all power when installing or adjusting unit. Failure to turn off all power could result in serious injury or death!

Read all instructions thoroughly! Check local codes and install to meet requirements - Refer to National Electrical Code (NFPA 70)

Alarm unit MUST be mounted indoors, failure to do so will damage unit and void warranty

Specifications

Mechanical

1/2" electrical

knockout

.18"

diameter mounting

holes(2)

Enclosure powder coated paint for indoor use

Six foot power cord

1/2" electrical knock-out

Part Number 7001 (Standard)

Description of Operation & Maintenance

The VERSA'LARM is a multipurpose alarm that can be used in a wide variety of applications such as: septic tanks, sumps, holding

tanks, pump chambers, water tanks, flow, pressure, condensate, temperature and any others where a "dry" contact can be connected

to the VERSA'LARM.

The VERSA'LARM is powered by 120 VAC coming from standard wall outlets and is transformed to 9 VDC. Installing a 9 Volt battery

provides battery back-up.

When a switch (signaling device) contact "closes" the buzzer and light will turn "on" and the optional auxiliary contacts will be activated.

Pressing the "silence" switch deactivates the buzzer and auxiliary contacts. When the alarm is remedied, the system automatically

resets itself.

Test product weekly. Make sure the green "power on" light is "on". Press the "Test" switch, the red alarm light and buzzer should turn

"on". If the battery backup system is utilized, unplug the wall mount power supply (the green light will be off). Now press the "Test"

switch, the red alarm light and buzzer will turn "on". If the buzzer sounds less loud then when tested with the normal power supply,

then replace the battery. Refer to instructions on installing/replacing the battery on page 2. Reconnect power supply when finished to

put the Versa'larm back into service.

Alarm Systems

Control Panels

PO Box 827

Hawley, MN 56549

4.0"

6.0"

Adaptor

Float Switches

Leak Detection Systems

(218) 483-3034

Electrical

Primary Power:

120 VAC, 50/60 HZ

Secondary Power:

Class 2, 9 VDC, 200 ma

Auxiliary Contacts:

Single Pole, Double Throw

(Optional)

Class 2, 24 VDC/24 VAC (50/60HZ),

500 ma MAXIMUM

Battery:

9 Volts (Not included)

Buzzer:

90 db @ 30 cm

103db@ 2 feet

Switch:

UL listed, 9 VDC, 200 ma minimum

(signaling device)

Single Pole, Single Throw

Model Number Nomenclature

Sensor Options

0 - no sensor, alarm panel only

H - 15', Normally Open float switch

L - 15', Normally Closed float switch

Alderon Industries, LLC

P.O. Box 827

Hawley, MN 56549

Page 1 of 2

Fax (218) 483-3034

Options

1-Auxiliary Contacts, SPDT

P/N 10026 Rev B

10/28/02

Phone: 218.483.3034

Fax: 218.483.3036

Page 1 of 2